Uniden UH-100 owner manual LCD Backlight Level Control

Page 20

LCD Backlight Level Control

The LCD backlight level can be changed to BRIGHT, DIM, or OFF.

To change the level simply press and hold the DUPLEX key for more than 1 .5 seconds.

IIEII

5

I..f 75.5SGMHz

, ,-, ~@

ILl re OFF

To change further, press and hold DUPLEX again.

' MEM

,,-,

f I ~ 75.5SGIIHz ILII,

.18.

19

Image 20

Contents Sundowner UH-100 Scanning Table of Contents TransmitterSection Controls I Indicators I Connectors 11 ~ Connectors FrontPanel Introduction @@ ~~ ~ Included with your UH-100Setting the Squelch Operation~15Q Selecting a ChannelUsing Repeater Channels TransmittingTo operate UH-100 in Duplex Mode LI @ OfF MEM, -, ~@ 1711OOMHz Drop-Out Delay Choosing a Priority Channel~ ~ Programming Scan ChannelsEM. ,-,s ...II~ I Channel Seeking OperationVoice Scrambler LCD Backlight Level Control LCD backlight level can be changed to BRIGHT, DIM, or OFFSelective Calling This is UH-100 Calling Making a CallILl Acknowledgment Tone~~~ $ TI Transmitting ID from Memory~I~ Receiving a Call~~~r ~~~~~GD e ILlGroup Calling 23450 23451 23452 23453 23454Tone squelch Receiver Quieting Receiving Calls when in Quiet Mode Activating the Tone Squelch Receiver Quieting~ ~~ Selcall Advance Programming 150- I ~@Page TSQ,- -IIS Radio ID Programming+~Pn.c Tone Period ProgrammingLead -In Delay Programming TSO Rsa Alarm Mode Programming II i~ Group Call Mode Programming ~A~Caller ID Decoding Service Memory Backup Care and MaintenancePreventive Maintenance Simplex Operating Mode Uhfcb Channel InformationDuplex Operating Mode Assignment Frequency MHzSpecifications GeneralReceiver Section Measurement ConditionsTransmitter Section Selcall Warranty UnidE!n@