Uniden UH-100 owner manual Controls I Indicators I Connectors

Page 4

Controls I Indicators I Connectors

Controls

,

unlden~UH.100-,,-,

tJtJ"",tJ m CAL 1.1£1.1 Tso ,

tJ""", DUP'11GS ,..- ..

tJ""", SRF..., ,-,

tJ""", 88H888M~~~~

tJtJ"",ItJ

tJtJtJtJtJtJ

1.LIQUIDCRYSTALDISPLAY(LCD) PANEL- Indicators for TX,CAL, MEM,TSQ, GS (OS), SCN, PRI, Channel Number, Frequency (SELCALL Code), Signal Strength Level (S), Transmit Power Level (RF), DUP and Scrambler.

2.UP/DOWNCHANNELSELECTOR -These controls are used to select the desired communication channel.

3.ON/OFF, VOLUME& SQUELCHCONTROLS ON/OFF &Volume Control (Centre Knob)

Turns the UH-100 power ON or OFF and adjusts the volume. Squelch Control (Outer Ring)

Eliminates background noise in the absence of an incoming signal.

4.PUSH-TO-TALK(PTT) SWITCH- Press to transmit and release to receive.

5.TONE CALLCONTROLBUTTON- Press to transmit SELCALLcodes, also used to access TX SELCALLIDprogramming.

6.DUPLEX/ LCD BACKLlGHTControl

a. Duplex Operation

Press this button momentarily to choose semi-duplex operation for Channels 1 through 8.

b. LCD Backlight Control

Press and hold this button to change the LCD backlight level BRIGHT - DIM - OFF.

7.OPENSCAN/GROUP SCAN CONTROL(OS/GS) - Switches operation between OPENSCANand GROUPSCANMode.

3

Image 4
Contents Sundowner UH-100 Scanning Table of Contents TransmitterSection Controls I Indicators I Connectors 11 ~ Connectors FrontPanel Introduction @@ ~~ ~ Included with your UH-100Setting the Squelch Operation~15Q Selecting a ChannelUsing Repeater Channels TransmittingTo operate UH-100 in Duplex Mode LI @ OfF MEM, -, ~@ 1711OOMHz Drop-Out Delay Choosing a Priority Channel~ ~ Programming Scan ChannelsEM. ,-,s ...II~ I Channel Seeking OperationVoice Scrambler LCD Backlight Level Control LCD backlight level can be changed to BRIGHT, DIM, or OFFSelective Calling This is UH-100 Calling Making a CallILl Acknowledgment Tone~~~ $ TI Transmitting ID from Memory~I~ Receiving a Call~~~r ~~~~~GD e ILlGroup Calling 23450 23451 23452 23453 23454Tone squelch Receiver Quieting Receiving Calls when in Quiet Mode Activating the Tone Squelch Receiver Quieting~ ~~ Selcall Advance Programming 150- I ~@Page TSQ,- -IIS Radio ID Programming+~Pn.c Tone Period ProgrammingLead -In Delay Programming TSO Rsa Alarm Mode Programming II i~ Group Call Mode Programming ~A~Caller ID Decoding Service Preventive Maintenance Care and MaintenanceMemory Backup Simplex Operating Mode Uhfcb Channel InformationDuplex Operating Mode Assignment Frequency MHzSpecifications GeneralTransmitter Section Measurement ConditionsReceiver Section Selcall Warranty UnidE!n@