Uniden UH-100 owner manual Measurement Conditions, Transmitter Section, Receiver Section

Measurement Conditions

::>owerSource	: 13.8V (DC)
I\ntenna Impedance	: 50 ohm
Test Temperature	:25°C
Modulation Frequency:	1 kHz (RXlTX)
Mean Signal Input Level:	1000 /lV
Reference Audio Output	: 500mW
Power
Reference Modulation
Deviation	: :i:3 kHz deviation
Audio Output Load	: 8 ohms resistive

Transmitter Section

Frequency Tolerance at 25°C (5 minutes after

turning on)	: :i:0.5 kHz
Carrier Power	: 5W (max)
Spurious Emission	:-40 dBm
Current Drain	: 1500mA

Modulation Frequency Response (1 kHz, 0 dB reference, at 1 kHz deviation)

Lower at 500 Hz	: -6 dB
Upper at 2.0 kHz	: +5 dB
Microphone Sensitivity	: 1.5mV
for 3 kHz Deviation
Maximum Deviation	: :i:4.5 kHz
at 1 kHz
at 6 kHz	: :i:1.5 kHz (max)

Receiver Section

Sensitivity at 12dB SINAD : 0.23 /lV or better

Overall Audio Fidelity	.
(1 kHz, 0 dB reference)	:+4 dB
Lower at 500 Hz
Upper at 2 kHz	:-6 dB
Adjacent Channel
Selectivity (:t:25kHz)	: 70 dB
Maximum Audio Output	:3W
Power
Audio Output Power at	:2W
10% THD
Hum & Noise Ratio at	:45 dB
Input 1mV
Squelch Sensitivity at
Threshold	: 0.1 /lV
Squelch Sensitivity at
Tight	: 1 /lV
Image Rejection Ratio	:55 dB
IF Rejection Ratio	: 100 dB
Oscillator Dropout	:9V
Voltage

48