Uniden UH-100 owner manual General, Specifications

Page 48

General

Channels

Frequency Range

Crystal Oscillator

Microphone

Speaker

Antenna Connector

Jacks & Connectors

Controls

Indicators

Cabinet Size

Weight

Operating Temperature

Power Requirements

SMA Approval

Accessories

Specifications

:40

:476.425MHz to 477.40MHz :4

:600 ohm, Dynamic Type

:8 ohm, 3.5W

:M-Type

:Mic 4P Metal

EXT SP 3.5<1>

DC Power 2P Type

:PRESS-TO-TALK Button (Microphone) TON E CALL Button (Microphone) SCAN/SEEK Button

OS/GS Button SCRAMBLE Button

BACK LIGHT CONTROL Button OFFNOLUME Control SQUELCH Control MEMORY Button

DUPLEX Button

TONE SQUELCH Button CHANNEL UP/DOWN Button

:DUPLEX Indicator TX Indicator

CALL indicator TSQ Indicator GROUP SCAN Indicator MEMORY Indicator CHANNEL Indicator PRI Indicator

S/RF Level Indicator SCAN Indicator

TX/RX FREQUENCY, 5 digits SELCALL ID Indicator SCRAMBLE Indicator

:W: 172 mm

H : 52 mm

D : 145 mm

:1.0 kg

:0° to +55°C

:13.8 VDC Nominal

:Type accepted under SMAS250

:DC power cable with built-in-fuse, microphone, microphone hanger, mounting bracket screw (2), washer (2) for microphone hanger, microphone hanger screw (2), washer star (2) for mounting bracket, rubber washer (2) for mounting bracket, knob (2) for mounting bracket

47

Image 48
Contents Sundowner UH-100 Scanning Table of Contents TransmitterSection Controls I Indicators I Connectors 11 ~ Connectors FrontPanel Introduction @@ ~~ ~ Included with your UH-100Setting the Squelch Operation~15Q Selecting a ChannelUsing Repeater Channels TransmittingTo operate UH-100 in Duplex Mode LI @ OfF MEM, -, ~@ 1711OOMHz Drop-Out Delay Choosing a Priority Channel~ ~ Programming Scan ChannelsEM. ,-,s ...II~ I Channel Seeking OperationVoice Scrambler LCD Backlight Level Control LCD backlight level can be changed to BRIGHT, DIM, or OFFSelective Calling This is UH-100 Calling Making a CallILl Acknowledgment Tone~~~ $ TI Transmitting ID from Memory~I~ Receiving a Call~~~r ~~~~~GD e ILlGroup Calling 23450 23451 23452 23453 23454Tone squelch Receiver Quieting Receiving Calls when in Quiet Mode Activating the Tone Squelch Receiver Quieting~ ~~ Selcall Advance Programming 150- I ~@Page TSQ,- -IIS Radio ID Programming+~Pn.c Tone Period ProgrammingLead -In Delay Programming TSO Rsa Alarm Mode Programming II i~ Group Call Mode Programming ~A~Caller ID Decoding Service Care and Maintenance Preventive MaintenanceMemory Backup Simplex Operating Mode Uhfcb Channel InformationDuplex Operating Mode Assignment Frequency MHzSpecifications GeneralMeasurement Conditions Transmitter SectionReceiver Section Selcall Warranty UnidE!n@