Uniden UH-100 owner manual ~A~, Group Call Mode Programming

Page 42

Group Call Mode Programming

There are two ways the Group Call Code is transmiitted.

The Uniden UH-100 can be programmed to accept either format.

Group 1 setting recognizes a group call transmitted with equal tone period. Le. Calling 100 radios, with a tone period setting of 40 mSec.

Group 2 setting recognizes a group call transmitted with the first Group Call Tone period extended by 3 times the original tone period setting (this is also the default setting).

~A~

40mSec---+I I+- I -.j 120mSecI+-

To change the Group Call setting.

From the main menu, using the... or ~ key, go to the Group Call Mode Programming Menu. (If you have never changed the Group Call setting before, its default is Group 2)

Press the MEM key to start programming. The Alarm setting on display will flash. This indicates that you can now change the setting.

To change, use the... or ~ key.

When completed, press the MEM key. The new Group Call setting stops flashing and will be stored in the radio memory.

To return to normal operation, press and hold the OS/GS key for about 1.5 seconds,

or press either the... or ~ key to go to the next programmable parameter.

TSQ,-, -'llel@

GroUP- LI C ~~

~@~TSQ..P ~ I""MIC

TSQ",-, -,'

GroUP- LI L

4

I~I_~~

GroUP-

GroUP.

41

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Sundowner UH-100 Scanning Table of Contents TransmitterSection Controls I Indicators I Connectors 11 ~ Connectors FrontPanel Introduction @@ ~~ ~ Included with your UH-100Setting the Squelch Operation~15Q Selecting a ChannelUsing Repeater Channels TransmittingTo operate UH-100 in Duplex Mode LI @ OfF MEM, -, ~@ 1711OOMHz Drop-Out Delay Choosing a Priority Channel~ ~ Programming Scan ChannelsEM. ,-,s ...II~ I Channel Seeking OperationVoice Scrambler LCD Backlight Level Control LCD backlight level can be changed to BRIGHT, DIM, or OFFSelective Calling This is UH-100 Calling Making a CallILl Acknowledgment Tone~~~ $ TI Transmitting ID from Memory~I~ Receiving a Call~~~r ~~~~~GD e ILlGroup Calling 23450 23451 23452 23453 23454Tone squelch Receiver Quieting Receiving Calls when in Quiet Mode Activating the Tone Squelch Receiver Quieting~ ~~ Selcall Advance Programming 150- I ~@Page TSQ,- -IIS Radio ID Programming+~Pn.c Tone Period ProgrammingLead -In Delay Programming TSO Rsa Alarm Mode Programming II i~ Group Call Mode Programming ~A~Caller ID Decoding Service Care and Maintenance Preventive MaintenanceMemory Backup Simplex Operating Mode Uhfcb Channel InformationDuplex Operating Mode Assignment Frequency MHzSpecifications GeneralMeasurement Conditions Transmitter SectionReceiver Section Selcall Warranty UnidE!n@
Top Page Image Contents