Uniden UH-100 owner manual

Page 34

The illustration below outlines the user programmable parameter menu.

Once inside the programming mode, use the .& or T to scroll on the menu.

Press MEM to select. Change the setting using the .& or T key. Press MEM again to store and exit.

Programming Start

Radio ID

Programming

	Caller ID	Tone Period
	Caller ID	Programming
	Decoding	Programming

Group Call Mode	Lead-In Delay
Programming	Programming

Alarm Mode	Lead-In Tone
Programming	Programming

Press and Hold the OS/GS Key again OR switch the radio OFF then ON to exit this mode.

33

Image 34

Contents Sundowner UH-100 Scanning Table of Contents TransmitterSection Controls I Indicators I Connectors 11 ~ Connectors FrontPanel Introduction @@ ~~ ~ Included with your UH-100Setting the Squelch Operation~15Q Selecting a ChannelUsing Repeater Channels TransmittingTo operate UH-100 in Duplex Mode LI @ OfF MEM, -, ~@ 1711OOMHz Drop-Out Delay Choosing a Priority Channel~ ~ Programming Scan ChannelsEM. ,-,s ...II~ I Channel Seeking OperationVoice Scrambler LCD Backlight Level Control LCD backlight level can be changed to BRIGHT, DIM, or OFFSelective Calling This is UH-100 Calling Making a CallILl Acknowledgment Tone~~~ $ TI Transmitting ID from Memory~I~ Receiving a Call~~~r ~~~~~GD e ILlGroup Calling 23450 23451 23452 23453 23454Tone squelch Receiver Quieting Receiving Calls when in Quiet Mode Activating the Tone Squelch Receiver Quieting~ ~~ Selcall Advance Programming 150- I ~@Page TSQ,- -IIS Radio ID Programming+~Pn.c Tone Period ProgrammingLead -In Delay Programming TSO Rsa Alarm Mode Programming II i~ Group Call Mode Programming ~A~Caller ID Decoding Service Preventive Maintenance Care and MaintenanceMemory Backup Simplex Operating Mode Uhfcb Channel InformationDuplex Operating Mode Assignment Frequency MHzSpecifications GeneralTransmitter Section Measurement ConditionsReceiver Section Selcall Warranty UnidE!n@