Uniden UH-100 owner manual Alarm Mode Programming

Alarm Mode Programming

The UH-100 has two types of alarm set-up.

Set-up 1: Auto-Resume (Default setting)

When a Call is received in,

i)Normal Mode

The alarm will sound only for 10 seconds

ii)Tone Squelch Mode

The quieting circuit will open for 20 seconds. If left unanswered Tone Squelch condition resumes. The alarm will sound for 10 seconds only.

iii)Normal Mode / Tone Squelch Scanning

The alarm will sound only for 10 seconds.

If left unanswered, scanning RESUMES after 20 seconds. The CAL icon will be continuously lit on the display indicating that a call has been received. To look for the called channel, cancel SCAN and use the A or 'Ykey. The called channel will display a CAL when found.

Set-up 2: Continuous Alarm

When a call is received in,

i)Normal Mode

The radio emits a successive beeping alarm for 20 seconds then two successive beeps every four seconds continuously unless answered.

ii)Tone Squelch Mode

The Tone Squelch condition is cancelled.

The radio emits a successive beeping alarm for 20 seconds then two successive beeps every four seconds continuously unless answered.

iii)Normal Mode / Tone Squelch Scanning

Scanning is cancelled.

The radio emits a successive beeping alarm for 20 seconds then two successive beeps every four seconds continuously unless answered.

Note: Should you wish your radio to cancel scanning when a SELCALL is received, select the continuous alarm mode.

39