Kenwood TS-590S 63&+352&6625,  75$160,7,1&5017$/781,1* ,  6SHHFK3URFHVVRUIIHFW

Page 39

&20081,&$7,1*$,'6

Q 'DWD92;'HOD\7LPH

Select an appropriate delay time for after the audio signal input to the ACC2 or USB connector ends.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to select Menu No. 70.

2Press [M.IN]/ [SCAN (SG.SEL)] to set your desired delay time.

3Press [MENU] to exit Menu mode.

Q 86%$&&92;*DLQ

When using the ACC2 or USB connector for VOX transmission, take the time to properly adjust the VOX gain.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to select Menu No. 71 (USB connector) or Menu No. 72 (ACC2 connector).

2While sending an audio signal to the ACC2 or USB connector, adjust the value (default is 4) using [M.IN]/ [SCAN (SG.SEL)] until the transceiver reliably switches to transmit mode each time you send an audio signal to the connector.

3Press [MENU] to exit Menu mode.

63((&+352&(6625

The Speech Processor levels out large fluctuations in your voice while you speak. When using SSB, AM, or FM mode, this leveling action effectively raises

the average TX power (SSB/AM) or raises the deviation to an adequate level (FM), resulting in a more understandable signal. The amount of voice compression is fully adjustable. Using the Speech Processor makes it easier to be heard by distant stations.

Level

 

Speech

Time

Processor

 

OFF

 

Level

 

Speech

Time

Processor

 

ON

 

1Select USB, LSB, AM, or FM mode.

2Press [PROC (LEV)] to turn the Speech Processor ON.

• “” appears.

3Press and hold [PROC (LEV)] to enter the Speech Processor input level adjustment mode.

4As you speak into the microphone, turn the MULTI/CH control so that the compression meter indicates that the compression level is around

10 dB while you speak.

Using higher compression will not improve your signal clarity or apparent signal strength. Excessively compressed signals are more difficult to understand due to distortion and are less pleasant to hear than signals with less compression.

5Press and hold [PROC (LEV)] to exit the Speech Processor input level adjustment mode.

6Press [MIC (CAR)] to enter the Speech Processor output level adjustment mode.

As you speak into the microphone, turn the MULTI/CH control so that the ALC meter reflects according to your voice level, but does not exceed the ALC limit. Press [MIC (CAR)] to exit when you finish the adjustment.

Q 6SHHFK3URFHVVRU(IIHFW

When using the Speech Processor, you can change its effect.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to select Menu No. 29.

2Press [M.IN]/ [SCAN (SG.SEL)] to set the Processor Effect to SOFT or HARD (default).

3Press [MENU] to exit Menu mode.

;,7 75$160,7,1&5(0(17$/781,1*

Similar to RIT, XIT provides the ability to change your transmission frequency by ±9.99 kHz in steps of

10 Hz without changing your reception frequency. If the Fine Tuning function is ON, the frequency step size becomes 1 Hz (±9.999 kHz).

1Press [XIT].

• “” and the XIT offset appear.

2If required, press [CL] to reset the XIT offset to 0.

3Turn the RIT/ XIT control to change your transmit frequency.

4To turn XIT OFF, press [XIT].

” and the offset frequency disappear. The transmission frequency is returned to the frequency that was selected prior to step 1.

Note:

XIf the Fine Tuning function is ON, you can adjust the frequency within ±9.99 kHz.

XThe frequency shift set by the XIT control is also used by the RIT function. Therefore, changing or clearing the XIT offset also affects the RIT offset.

XWhen the XIT frequency goes beyond the available transmission frequency, the transceiver automatically stops transmitting.

31

Image 39
Contents Notification TS-590SPage 2567$57,1 +$1.28$7856 127,&727+865Instruction Action Accessory Comment Quantity Type1*&21917,2162//2 6833/,$&&6625,635&$87,216 217176 Rejecting Interference Memory Features217176 Data CommunicationsSpecifications Installing OptionsTroubleshooting Optional Accessories+71,1*3527&7,21 167$//$7,21$1711$&211&7,21 5281&211&7,2187,/,=,1*7+%$ $&&6625&211&7,21653/$&,1*866 GND Stby MIC GND MIC PTT Down Meter DRV KEY Delay77,1*$&48$,17 52173$1*77,1*$&48$,17 RX/4 REC CH1 RECCH2 REC CH3 RECAbcd ,63/$*77,1*$&48$,17 523+21 $53$11*92$2592% 235$7,1*%$6,&6+,1*325212 $-867,1*7+92/80Gene 1*$%$11*$02 235$7,1*%$6,&6Meter Name Parameters Measured $-867,1*7+648/&+08/7,81&7,21075 781,1*$5481Press PWR TX Moni 75$160,77,11*75$160,66,21325 523+21*$,1018$&&66 0186783+$7,6$018 018$018%0186783 018&21,*85$7,21Number of Quick Memory Channels ON/ OFF Auto Mode OperationAM MULTI/CH Control FM MULTI/CH ControlBUG KEY Function CW WeightingTIME-OUT Timer CW Rise TimeUSB Port Baudrate Constant RecordingTX Inhibit COM Port BaudrateACC2 VOX Gain Auto Power OFFPower on Message USB VOX GainAvailable alphanumeric characters +$5$&75175$6,&&20081,&$7,216 66%75$160,66,2175$160,66,21 $075$160,66,21 $552%$1,7+250%$6,&&20081,&$7,216 6,72153,7&+5481 $55,5/932521066$ %$6,&&20081,&$7,216 $872=52%$7+$1&&20081,&$7,216 63/,75481&235$7,2167 75$160,66,215481&67 53$75235$7,21 1+$1&&20081,&$7,21675$160,77,1*$721 Press AGC/T SEL &7&66235$7,217215481&,6&$1  6HOHFWLQJD7RQHUHTXHQF\665481&,6&$1 5266721 LUHFWUHTXHQF\QWU\ 20081,&$7,1*$,637,21 1*2855481&20081,&$7,1*$,6  5&,9,1&5017$/781,1* $*& $8720$7,&*$,1&21752/  HOD\7LPH 75$160,66,2192 92,&235$775$160,66,21  0LFURSKRQH,QSXW/HYHO 6SHHFK3URFHVVRUIIHFW Press M.IN/ Scan SG.SEL to set your desired delay time63&+352&6625  75$160,7,1&5017$/781,1*  UHTXHQF\5HVSRQVH&XUYHV 75$160,7,1+,%,786/2&.287 +$1*,1*5481&+,/75$160,77,17521,&.502 %5$.,17521,&.5 86,1*60,%5$.,1258//%5$.,1.81&7,21 &20081,&$7,1*$,6 7,02$872,*+7,1 066$*0025 ,QVHUW.H\LQJ 5481&&255&7,2125 7UDQVPLWWLQJ&0HVVDJHV  &KDQJLQJWKH&6LGHWRQH9ROXPH&20081,&$7,1*$,6 $872&7,166%02 831.3$/02$327$1$6+3$/326,7,216 A./ Canada Iaru Region Europe/ Africa $7$&20081,&$7,216$,27/73 577 +$66+,7.,1*%$8 36.  DWD0RGH 1*,1755163,/756 +$1*,1*7+63,/75%$1,7+$7&$1&/ 66%$0 5-&7,1*,17551$872127&+,/75 66% $18$/127&+,/75 66%&6. 5956 5&37,21 12,6%/$1.535$03/,,5 $7718$725 6LPSOH&KDQQHOV 0025$78560025&+$11/6 6725,1*$7$,10025 0HPRU\6FUROO 0025$7856 00255&$//$16&52002575$165  0HPRU\5HFDOO6725,1*5481&5$1*6 0025$78560025&+$11/1$0 48,&.00250025&+$11//2&.287 $6,1*0025&+$11/670325$55481&&+$1*6 0025$7856 180%5248,&.0025&+$11/66725,1*,17248,&.0025 $//,1*48,&.0025&+$11/6Press and hold Scan SG.SEL 1250$/6&$1926&$1 352*5$06&$1352*5$06&$13$57,$//6/2 6&$1$//&+$11/6&$1 00256&$16&$1 $1+2 $15680 6FDQ*URXS6HOHFW 48,&.00256&$16&$1 52836&$1  0HPRU\*URXS$8720$7,&$1711$7815 235$725&2191,1&6$1711$6 $32 $XWR3RZHU2 35677,1 Internal Antenna Tuner Preset Frequency Range MHz$87202 235$725&2191,1&6Mode Morse Code Output 81&7,21Beep Type Meaning 63/$ $5$03/,,5&2175281&7,216 352*5$00$%/81&7,21.6 75$16&,9552173$1523+21.6 63548$/,=5 2877,0575$169575 48,&.$7$75$165 021,725325 781 7UDQVIHUULQJDWD 203875&21752235$725&2191,1&6 86,1*48,&.75$165 20081,&$7,213$5$0756 $XGLR/HYHO6HWWLQJV 235$725&2191,1&6 751$/$8,2677,1*6+$1*,1*7+6,*1$/257+&20750,1$ 21752//,1*7+766520$3 6HQGLQJ0HVVDJHV 235$725&2191,1&6 25,1*066$*6066$*3/$%$  &KHFNLQJ0HVVDJHV &KDQJLQJ0HVVDJH3OD\EDFN9ROXPH Operations using VOICE1 Announcement2167$175&25,1 92,&*8SET FSK REV/ FM/AM 9RLFH*XLGH$QQRXQFHPHQW/DQJXDJH 05*1&&$// .7321/  9RLFH*XLGH$QQRXQFHPHQW9ROXPH  9RLFH*XLGH$QQRXQFHPHQW6SHHG5266%$153$75 3$&.7&/8675781235$7,21 6WDUWLQJ6N\&RPPDQG,,RSHUDWLRQ &200$1&200$1,,,$*5$0 353$5$7,21$&&&211&725 211&7,1*35,3+5$/48,3017750,1$/6&5,37,216 20&211&725&211&725 $7&211&725 IRU$7 203875 203$7,%/75$16&,95&211&7,1*35,3+5$/48,3017 +0+/,1$5$03/,,5 577235$7,2171&$10&3 $1711$78155266%$153$75 167$//,1*237,216 5029,1*7+%27720&$692,&*8, 6725$*81,7 TS-590S transceiver without SO-3 627&2551&5481&&$/,%5$7,21 ,167$//,1*237,21635&$87,216 02%,/%5$&.7659,&127 7528%/6+227,115$/,1250$7,21 659Followed Problem Probable Cause Corrective Action7528%/6+227,1 7528%/6+227,17528%/6+227,1 MCP 567 52352&6625567$/677,1*6 925671751$/%$76 235$7,21127,&63256833 1751$/&22/,1*$1VGS-1 237,21$/$&&6625,663&,,&$7,216 $XGLRRXWSXW ŸGLVWRUWLRQ 63&,,&$7,216 TransmitterSSB/ CW/ FSK/ AM CW/ FSK
Related manuals
Manual 76 pages 27.47 Kb