,167$//,1*237,216
627&;2
The
1Remove the CN503 connector and TCXO PCB screw, as shown below.
CN503
TCXO PCB
2Remove the TCXO PCB.
3Insert the
4Solder all pins on the reverse side of the PCB.
5
6Connect the CN503 and tighten the screw.
7Move the C903 and C904 jumper as shown below.
TC501 | CN904 |
CN903 |
5()(5(1&()5(48(1&<&$/,%5$7,21
Note: The transceiver is adjusted at the factory prior to shipping. Do not perform this adjustment unless it is necessary.
1Set the following on the transceiver:
•Mode: CW
•AF control: Center
•Menu No. 34 (CW RX pitch): 800 Hz
•SHIFT control: 800 Hz
•RIT function: OFF
•
2Remove the bottom case (10 screws) from the transceiver.
3Tune in a standard frequency station such as WWV or WWVH at, for example, 10.000.00 MHz or 15.000.00 MHz.
•Adjust the Tuning control so that the display reads the exact frequency of the station.
•You should hear a beat tone of approximately 800 Hz.
•For 800 Hz:
faf = (fdisplay/15.600 x ∃freference) + 800 Hz where ∃freference is the shift from the 15.6 MHz reference frequency.
4Close your CW key. You will hear a transmit sidetone of approximately 800 Hz.
•This sidetone produces a double beat tone when it combines with the received signal.
•Adjust the AF control to hear the double beat clearly.
•For 800 Hz:
fsidetone = 800 Hz ±50 ppm (= 800 ±0.04 Hz) where ∃freference is the shift from the 15.6 MHz reference frequency.
5TS-590S transceiver without SO-3:
Adjust the trimmer (TC501) to minimize the frequency difference between the received 800 Hz tone and the 800 Hz sidetone.
TS-590S transceiver with SO-3:
Adjust the trimmer inside the
Note:
XTo avoid misplacing the jumper, keep it attached to 1 pin of C903 or C904.
XWhen removing the
8Replace the bottom case (10 screws).
72