Furuno DS-60 installation manual Installation using the transducer tank DS-660

1. INSTALLATION

1.4.2Installation using the transducer tank DS-660

8

7

6

1615

1312 11

	5
	2
Hull	4	1	10 9

Transducer tank DS-660, sectional view

1.Remove flange (4), fixing plate (5), fixing gland (6), washer (7) and gasket (8) from the tank.

2.Set the tank to the place which was selected at paragraph 1.4.1.

The “FORE-AFT” line on the tank must be parallel with the line between ship’s fore and aft (error: within 3°).

For horizontal direction, the bottom of the tank (2) must be parallel with the draft.

AFT FORE

Ship’ s bow

DS-660 Tank, top view

3.Weld the tank (2) to the ship’s hull. The doubling and welding methods are left up to the ship- yard.

4.Paint the tank (2), flange (4) and fixing plate (5) the same color as the ship’s body. Paint only gray-colored areas; for other part, seal with a masking tape.

5.Apply liquid gasket (supplied) to the top of the transducer evenly.

6.Mount the fixing plate (5) on the transducer (1).

7.Attach seal washer (16) to hex. bolt M8x12 (15).

8.Use hex. bolt (15)(16) assembled at step 7 to fasten the transducer (1) and fixing plate (5).

1-7