Furuno installation manual Display Unit DS-600, Mounting consideration, Flush mount

1.INSTALLATION

NOTICE

Do not apply paint, anti-corrosive sealant or contact spray to coating or plastic parts of the equipment.

Those items contain organic solvents that can damage coating and plastic parts, especially plastic connectors.

1.1Display Unit DS-600

Mounting consideration

The display unit can be installed on a desktop, on the underside of a table, or flush mounted in a panel. When you select a mounting location, keep in mind the following points:

•Locate the display unit away from exhaust pipes and vents.

•Select an installation location that is well ventilated.

•Locate the display unit where shock and vibration are minimal.

•Allow enough maintenance space at the sides and rear of the display unit and leave enough slack in cables to facilitate maintenance and servicing.

•Observe the compass safe distances (see page i) to prevent the interference to a magnetic compass.

•The nominal viewing distance for the display unit is 1 m. Select a suitable mounting location considering that distance.

Flush mount

See the outline drawing in the back of this manual. Before you fasten the display unit to the cutout, first connect the cables referring to chapter 2.

1. Make a cutout in the mounting location as shown in the illustration below.

223+0.5 (8.78”)

18 (0.71”)

228+1 (8.98”) (for outdoor)

232+1 (9.13”)

(for indoor)

223+0.5 (8.78”)

228+1 (8.98”)

(for outdoor)

240 (9.45”)

232+1 (9.13”) (for indoor)

12 (0.47”) 78 (3.07”)

240 (9.45”)

Pilot hole	18 (0.71”) or	22 (0.87”)	Fixing hole (4- 6)
(four places)	(for outdoor)	(for indoor)

1-1