Furuno DS-60 installation manual Hex. bolt 15 Seal washer Fixing plate

Page 14

1. INSTALLATION

9.Use M16 nut (11), spring washer (12) and flat washer (13) to fix the transducer (1) w/fixing plate to the fixing flange (4).

M16 hex. nut (11)

M16 spring washer (12)

M16 flat washer (13)

Transducer (1)

Fixing flange (4)

10.For the transducer DS-631, do the following steps:

Hex. bolt (15) Seal washer (16)

Fixing plate (5)

1)Attach the grommet (supplied) to the location marked with a white line on the transducer cable.

2)Fix the grommet attached at step 1) to the notch shown below, by using the cable fixing plate (17), hex. bolt M6x12 (18), spring washer M6 (19).

3)Pass the connector at the end of the transducer cable between the transducer and M16 bolt, and attach the notch as shown below.

Transducer cable

Attach the connector to this notch.

Notch

(for grommet)

Pass the cable between the transducer and this bolt.

White mark

Grommet

Cable fixing plate (17)

M6 spring washer (19)

Hex. bolt M6x12 (18)

4)Connect the cable assy. (supplied) to the connector attached at step 3). Clean the connector faces and pins before the connection.

1-8

Image 14

Contents Installation Manual Iii00017233810 Safety Instructions System Configurations Equipment Lists Standard supplyOptional Supply Flush mount Display Unit DS-600Mounting consideration Hanger assembly Type OP26-8, Code No Desktop or table underside mountHow to set the cosmetic cap and alarm lid assy Installation considerations Transceiver Unit DS-620 Distributor Unit DS-610 Installation location TransducerInstallation using the transducer tank DS-660 Transducer tank DS-660, sectional viewHex. bolt 15 Seal washer Fixing plate Hex. bolt M6x20 Spring washer M6 Cable assy Metal fixing Transducer tank, sectional view Installation with gate valve DS-661 DS-661 gate valve, sectional viewInstallation Installation Installation How to open the gate valve Junction Box DS-640 option Mounting procedure Mounting considerationsApply silicon rubber to M10 bolts as shown below Pass the cable through the cable gland as shown below Remote Controller RD-501/Dimmer Controller RD-502 option How to change orientation of the front cover of DS-605Leveling adjustment Rate-of-Turn Gyro DS-340 optionThis page is intentionally left blank Wiring Precautions for cable installationConnection of Wago connector Top cover Cable clamps, entrancesTB3 TB1 TB5 TB2 TB4 TB8 DS-610 Distributor Unit DS-620 Transceiver unit DS-600 Display unit DS-600, example of connection Junction Box DS-640, option DS-640 Junction BoxMenu Settings How to Use the Service MenuMenu item Meaning Option How to set ship’s data How to Set the System MenuHow to show the System menu How to enter offset values Meaning Setting rangeHow to correct the ship’s speed This page is intentionally left blank Calculation with transit posts AP-1Milepost run AP-2 Calculation with DS-60AP-3 Appendix 2 JIS Cable Guide AP-4+/05+105+0&4#9+014440%10. #% #6 #6 52#42#465.+5614 5 #%%5514+5 Page Page Page Dec/08 R.Esumi Mar/09 R.Esumi Dec/08 R.Esumi 14/Jul/09 R.Esumi 14/Jul/09 R.Esumi 26/Oct/09 R.Esumi Dec/08 R.Esumi Dec/08 R.Esumi Dec/08 R.Esumi Doppler Sonar