Furuno DS-60 installation manual Pass the cable through the cable gland as shown below

1. INSTALLATION

3) Pass the cable through the cable gland as shown below.

Gasket*

Washer*

{

Clamping gasket

TTYCYS-4 cable

*: Attached inside the cable gland

4)Put the flush mounting sponge to the flange from the rear side of the DS-600.

5)Open the front cover of the DS-605 and connect the ground wire attached inside the DS- 605 to the ground terminal on the rear of the DS-600.

6)Connect the cables to the DS-600. Refer to chapter 2.

3.Remove each binding head screw from four corners of the DS-605 and set the D-600 to the DS-605.

4.Apply silicon grease to the binding head screws and fix the DS-600 to the DS-605 with four binding head screws.

5.Tighten the clamping glands to fix the cables.

6.Apply the putty to the cable glands for waterproofing.

7.Connect the ground terminal for the DS-605 to the ground terminal on the hull with the IV-1.25 sq. wire.

1-19