Furuno DS-60 Desktop or table underside mount, Hanger assembly Type OP26-8, Code No

1. INSTALLATION

Note: Dimensions for the cutout are different depending on the mounting location, indoor or out- door. For the outdoor mouting, ask dockyard to construct a waterproof case for the display unit.

2.Make four pilot holes for self-tapping screws (diameter: 5 mm) in the location indicated in the illustration on page 1-1.

3.Insert the sponge to the display unit from the rear side.

4.Set the display unit to the cutout and fasten the display unit with four self-tapping screws (5x20).

5.Set a cosmetic cap to each fixing hole on the front panel. See page 1-3.

Desktop or table underside mount

The display unit can be mounted on a desktop or on the underside of a table using the optional hanger. See the outline drawing for details.

Hanger assembly (Type: OP26-8, Code No.: 000-016-313-00)

Name	Type	Code No.	Qty
Self-tapping screw	5x20	000-171-997-10	4
Binding head screw	M5x12	000-171-999-10	4
Hanger assy.	OP26-8-1	001-081-920-00	1

1.Remove the hanger mounting plate from the hanger assembly.

2.Fasten the hanger mounting plate to the display unit from the left side and right side with four binding head screws (M5x12).

Hanger mounting plate (left side)

Screw (M5x12)

3.Make a four pilot holes for self-tapping screws (5x20) in the mounting location.

4.Fix the hanger to the mounting location with four self-tapping screws (5x20).

5.Screw knobs into the display unit loosely.

6.Set the display unit to the hanger.

7.Tighten the knobs to fasten the hanger to the display unit.

1-2