Teledyne HEATED THC, SERIES 4030 manual Flame Ignition, Fuel

Page 30

Operation

4.2.4Fuel

1.Open the main valve on the tank and set the fuel tank pressure regulator to 30 psig.

3.Adjust the Fuel regulator until its pressure gauge reads the recommended pressure of 3.5 psig.

Note: Adjust fuel settings only when the red LED (flame failure light) is off.

TELEDYNE ANALYTICAL INSTRUMENTS

 

SPAN

SAMPLE

TEMP. GAUGE

SPAN GAS

BYPASS FLOW

Figure 4-1: Front Panel View of Regulator and Gages

4.3 Flame Ignition

Observe that after warm up count down timer reaches zero (timer to preheat the sensor), the amber heater lamp is blinking (indicating that

Teledyne Analytical Instruments

28

Image 30
Contents Series 4030 Heated THC Copyright 2004 Teledyne Analytical Instruments Safety Messages Series Additional Safety Information Series Procedure for Removal of Internal Inaccessible Shock Hazards Series Main Features of the Analyzer IntroductionPrinciple of Operation Analyzer DescriptionApplications IntroductionSample System Input PortingFuel and Blanket Air Systems Detection CellGas Flow Control System Flame Ionization Detection CellIntroduction Anode Power Supply Electrometer-AmplifierFlame Guard Circuit Flame Ignition CircuitUnpacking the Analyzer Mounting the AnalyzerElectrical Power Connections User ConnectionsGas Connections Installation Electrical Connections Equipment Interface Connector Pin Arrangement Pin Function Threshold Alarm Pin Contact Pin out of 50 pins D-Sub Connector Pin Out TableCommands via RS-232 Input 4 RS-232 PortRequired RS-232 Options Supporting GasesSample Bypass Vent 1 Air Placing the System in OperationActivating the Support Gases Carrier GasFlame Ignition FuelIgnition and/or Flame Guard Circuit Failure Analyzer OperationVerification of the Flame Guard Circuit Sample PumpOperation Default Parameters Style ConventionsNavigation and Data Entry EnterEscape Menu Structure LineMain Menus Autocal is not available for standard configurations Logout Span ANALOG-OUT Adjust Setting up an AUTO-CAL Adjusting the GainPassword Protection Entering a Password Repeat Password Entry Screen Logging Out System Self-Diagnostic Test Model ScreenSpan Alarms Function AL-2 Source SMP Range Function Change Stream is not available for standard configurations Changing StreamAnalog output Adjustment Advanced User Functions StandbyTiming Recommended Spare Parts List Qty DescriptionDrawing List Analytical Instruments