Teledyne SERIES 4030, HEATED THC manual Password Protection

Page 43

Operation

To setup the GAIN:

1)From the Analysis Screen, press an arrow key to enter the Setup Mode. The VFD will display the first 2 lines of functions available.

________________________________________________

-> GAIN ADJUST

PASSWORD

________________________________________________

<▲▼> If the arrow is not adjacent to the GAIN ADJUST menu item, use the ▲▼ keys to move the arrow to the proper position.

<Enter> Press <Enter> to activate the function and move you to the next screen.

________________________________________________

-> GAIN 1

________________________________________________

Note, for instruction on how to, please refer to the section 4.4.3 Navigation and Data Entry.

In the example, the number to the right of the word 'GAIN' is 1, this reflects a gain of x10.

4.4.6 Password Protection

Before a unique password is assigned, the system assigns TAI by default. If the password is the default, it will be displayed automatically. The operator just presses <Enter> from the any of the MAIN MENU items to be allowed access to that item's sub menu. If the password has previously been changed from the default then the initial display will be 'A' 'A' 'A', and the correct letters must be input.

If user has LOGGED OUT, then only the following SUB MENU procedures may be executed:

14.PASSWORD

15.LOGOUT (which only repeats the logout)

16.MODEL

Teledyne Analytical Instruments

41

Image 43
Contents Series 4030 Heated THC Copyright 2004 Teledyne Analytical Instruments Safety Messages Series Additional Safety Information Series Procedure for Removal of Internal Inaccessible Shock Hazards Series Introduction Main Features of the AnalyzerAnalyzer Description Principle of OperationIntroduction ApplicationsInput Porting Sample SystemFlame Ionization Detection Cell Detection CellGas Flow Control System Fuel and Blanket Air SystemsIntroduction Electrometer-Amplifier Anode Power SupplyFlame Ignition Circuit Flame Guard CircuitMounting the Analyzer Unpacking the AnalyzerUser Connections Electrical Power ConnectionsGas Connections Installation Electrical Connections Equipment Interface Connector Pin Arrangement Pin Function Threshold Alarm Pin Contact Pin Out Table Pin out of 50 pins D-Sub Connector4 RS-232 Port Commands via RS-232 InputSupporting Gases Required RS-232 OptionsSample Bypass Vent Carrier Gas Placing the System in OperationActivating the Support Gases 1 AirFuel Flame IgnitionSample Pump Analyzer OperationVerification of the Flame Guard Circuit Ignition and/or Flame Guard Circuit FailureOperation Style Conventions Default ParametersEnter Navigation and Data EntryEscape Line Menu StructureMain Menus Autocal is not available for standard configurations Logout Span ANALOG-OUT Adjust Adjusting the Gain Setting up an AUTO-CALPassword Protection Entering a Password Repeat Password Entry Screen Logging Out Model Screen System Self-Diagnostic TestSpan Alarms Function AL-2 Source SMP Range Function Changing Stream Change Stream is not available for standard configurationsAnalog output Adjustment Standby Advanced User FunctionsTiming Qty Description Recommended Spare Parts ListAnalytical Instruments Drawing List