Teledyne SERIES 4030, HEATED THC manual Recommended Spare Parts List, Qty Description

Page 55

Appendix

Recommended Spare Parts List

Qty.

P/N

Description

1

B74671

PC board, Flame guard & anode power supply

1

B74677

PC board, Electrometer-amplifier

1

B30927

PC board, Temperature control

1

C75825A

Micro-processor PC board

1

A46128

Coaxial cable

1

B-13207

Sensor Assy.

1

C62371A

Display PCB Assy.

1

B74674A

Interface to Motherboard PCB Assy.

1

C65507A

Backpanel/Power Supply PCB Assy.

1

B74677A

Electrometer PCB Assy.

1

L79

Lamp, neon

1

F77

Fuse, 6.25A (3 AG)

1

L156

Lens, red

1

L154

LED, red

1

A33748

Thermistor assembly

1

V825

Ten-way valve

1

CP2408

PID temperature controller

A minimum charge of US $20.00 is applicable to spare parts orders.

IMPORTANT: Orders for replacement parts should include the part number and the model and serial number of the system for which the parts are intended.

Teledyne Analytical Instruments

53

Image 55
Contents Series 4030 Heated THC Copyright 2004 Teledyne Analytical Instruments Safety Messages Series Additional Safety Information Series Procedure for Removal of Internal Inaccessible Shock Hazards Series Introduction Main Features of the AnalyzerAnalyzer Description Principle of OperationIntroduction ApplicationsInput Porting Sample SystemFlame Ionization Detection Cell Detection CellGas Flow Control System Fuel and Blanket Air SystemsIntroduction Electrometer-Amplifier Anode Power SupplyFlame Ignition Circuit Flame Guard CircuitMounting the Analyzer Unpacking the AnalyzerUser Connections Electrical Power ConnectionsGas Connections Installation Electrical Connections Equipment Interface Connector Pin Arrangement Pin Function Threshold Alarm Pin Contact Pin Out Table Pin out of 50 pins D-Sub Connector4 RS-232 Port Commands via RS-232 InputSupporting Gases Required RS-232 OptionsSample Bypass Vent Carrier Gas Placing the System in OperationActivating the Support Gases 1 AirFuel Flame IgnitionSample Pump Analyzer OperationVerification of the Flame Guard Circuit Ignition and/or Flame Guard Circuit FailureOperation Style Conventions Default ParametersEnter Navigation and Data EntryEscape Line Menu StructureMain Menus Autocal is not available for standard configurations Logout Span ANALOG-OUT Adjust Adjusting the Gain Setting up an AUTO-CALPassword Protection Entering a Password Repeat Password Entry Screen Logging Out Model Screen System Self-Diagnostic TestSpan Alarms Function AL-2 Source SMP Range Function Changing Stream Change Stream is not available for standard configurationsAnalog output Adjustment Standby Advanced User FunctionsTiming Qty Description Recommended Spare Parts ListAnalytical Instruments Drawing List