Teledyne SERIES 4030, HEATED THC manual Additional Safety Information

Page 5

Series 4030

Additional Safety Information

DANGER

COMBUSTIBLE GAS USAGE

WARNING

This is a general purpose instrument designed for usage in a non-hazardous area. It is the customer's responsibility to ensure safety especially when combustible gases are being analyzed since the potential of gas leaks always exist.

The customer should ensure that the principles of operating of this equipment are well understood by the user. Misuse of this product in any manner, tampering with its components, or unauthorized substitution of any component may adversely affect the safety of this instrument.

Since the use of this instrument is beyond the control of Teledyne, no responsibility by Teledyne, its affiliates, and agents for damage or injury from misuse or neglect of this equipment is implied or assumed.

WARNING: HYDROGEN GAS IS USED IN THIS INSTRUMENT AS A FUEL. HYDROGEN IS EXTREMELY FLAMMABLE. EXTREME CARE MUST BE USED WHEN WORKING AROUND GAS MIXTURES CONTAINING FLAMMABLE GASES.

A Successful leak check was performed at TI/AI on the sample system of this instrument prior to calibration, testing and shipping. Ensure that there are no leaks in the fuel supply lines before applying power to the system.

Always purge the entire system before performing any maintenance and always leak check the system after removing any tubing or fittings on the sample

Teledyne Analytical Instruments

iii

Image 5
Contents Series 4030 Heated THC Copyright 2004 Teledyne Analytical Instruments Safety Messages Series Additional Safety Information Series Procedure for Removal of Internal Inaccessible Shock Hazards Series Introduction Main Features of the AnalyzerAnalyzer Description Principle of OperationIntroduction ApplicationsInput Porting Sample SystemGas Flow Control System Detection CellFuel and Blanket Air Systems Flame Ionization Detection CellIntroduction Electrometer-Amplifier Anode Power SupplyFlame Ignition Circuit Flame Guard CircuitMounting the Analyzer Unpacking the AnalyzerGas Connections Electrical Power ConnectionsUser Connections Installation Electrical Connections Equipment Interface Connector Pin Arrangement Pin Function Threshold Alarm Pin Contact Pin Out Table Pin out of 50 pins D-Sub Connector4 RS-232 Port Commands via RS-232 InputSupporting Gases Required RS-232 OptionsSample Bypass Vent Activating the Support Gases Placing the System in Operation1 Air Carrier GasFuel Flame IgnitionVerification of the Flame Guard Circuit Analyzer OperationIgnition and/or Flame Guard Circuit Failure Sample PumpOperation Style Conventions Default ParametersEnter Navigation and Data EntryEscape Line Menu StructureMain Menus Autocal is not available for standard configurations Logout Span ANALOG-OUT Adjust Adjusting the Gain Setting up an AUTO-CALPassword Protection Entering a Password Repeat Password Entry Screen Logging Out Model Screen System Self-Diagnostic TestSpan Alarms Function AL-2 Source SMP Range Function Changing Stream Change Stream is not available for standard configurationsAnalog output Adjustment Timing Advanced User FunctionsStandby Qty Description Recommended Spare Parts ListAnalytical Instruments Drawing List