Mounting the bodypack receiver to a camera
Use the supplied camera kit to mount the receiver to the camera’s flash mount.
The camera kit consits of:
y1 perforated plate
y1 flash mount adapter
y2 square nuts
Determine where on the perforated plate the flash mount adapter will need to be fastened so that the receiver can best be attached to the camera.
At this position, place a square nut under the perforated plate .
Fasten the flash mount adapter to the perforated plate using the square nut.
Remove the belt clip.
Place the perforated plate | onto the rear of the receiver. |
Reinsert the belt clip.
SK 100 G2 bodypack transmitter
Inserting and replacing the batteries
For powering the SK 100 G2 bodypack transmitter, you can either use two 1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
Press the two unlocking buttons | and open the battery compartment |
cover . |
|
Insert the two batteries or the BA 2015 accupack as shown in the diagram on the left. Please observe correct polarity when inserting the batteries/ accupack.
Close the battery compartment. The battery compartment cover locks into place with an audible click.
Note:
For important informations on charging the accupack see: „Inserting and replacing the batteries“ on page 17.
Connecting the microphone/line cable
The microphone/line input is designed for the connection of both condenser microphones and instruments (e.g. guitars). DC powering of the condenser microphones is via the microphone/line input.
Connect the 3.5 mm jack plug from the microphone/line cable to the 3.5 mm jack socket (MIC/LINE) .
Lock the 3.5 mm jack plug by screwing down the coupling ring .
Via the operating menu, adjust the sensitivity of the microphone/line input (MIC/LINE) (see: „Adjusting the sensitivity (transmitters only)“ on page 32).
18