Sennheiser W100 manual Selecting the standard display, Entering a name

IMPORTANT!	Notes:
	If the squelch threshold is adjusted too high, the transmission range will
	be reduced. Therefore, always adjust the squelch threshold to the lowest
	possible setting. The squelch threshold is factory-preset to “LO”.
	When in the setting mode of the “SQELCH” menu, pressing the button
	(DOWN) for more than three seconds will switch the squelch off. “SQ.OFF”
	appears on the display. If no RF signal is being received, hissing noise will
	occur. This setting is for test purposes only.

	Selecting the standard display
DISPLY	Via the “DISPLY” menu, you can select the standard display:

Contents of standard display

selectable			SK 100 G2, SKM 100 G2,
Standard display	EM 100 G2	EK 100 G2
			SKP 100 G2
„FREQ“
„NAME“
„CHAN“		⎯

	Entering a name
NAME	Via the “NAME” menu, you can enter a freely selectable name for each trans-
	mitter and receiver. You can, for example, enter the name of the performer
	for whom the adjustments have been made.

The name can be displayed on the standard display and can consist of up to six characters such as:

yletters (without pronounciation marks),

ynumbers from 0 to 9,

yspecial characters e.g. () - . _ and spaces.

To enter a name, proceed as follows:

Press the SET button to get into the setting mode of the “NAME” menu.

The first segment starts flashing on the display.

With the / buttons you can now select a character. By briefly pressing a button, the display jumps either forwards or backwards to the next cha- racter. If you hold down a button, the display starts cycling continuously.

Press the SET button to change to the next segment and select the next character.

Have you entered the name completely? Press the SET button to store your setting and to return to the previous menu level.

34