Telex Q II - FOH specifications Q2 Operationand Maintenance Manual

Page 8

DDA shall not be liable for any damage caused to persons or property due to :-

i)Incorrect usage of the Equipment

ii)Other equipment attached to the Equipment, which is not approved by DDA

iii)Modifications made by non-authorised persons, or by using non-recommended parts, or incorrectly made.

In no circumstances shall DDA be liable for any indirect or consequential costs, damages or losses (including loss of business profits, operating time or otherwise) arising out of the use or inability to use the product, whether or not the likelihood of damage was advised to DDA or its distributor.

Fuses and filament lamps are specifically excluded from the warranty

This notice does not affect your statutory rights.

Q2 OPERATIONAND MAINTENANCE MANUAL 9601

8

Image 8

Contents II FOH Contents Declaration of Conformity General Information Left Centre RightQ2 in USE Left Centre Right Effects Matrix Outputs Warranty Q2 Operationand Maintenance Manual Dimensions Specifications Maximum GainFrequency Response DistortionQ2 Operationand Maintenance Manual Wiring Considerations Grounding Q2 Operationand Maintenance Manual Do not Disconnect the Mains Earth Cables Module Descriptions CUE Interlock Mode Master CUE Reset Matrix Section 20DB PAD Input Module LO MID EqualiserHI MID Auxiliaries PREDIR LCR Routing and Status PANMono Meter CUE FaderSafe Mute GroupConnectors and PIN Assignments MIC InputLine Input Insert SendVCA Input Module EXT VCA/MUTE Group 1 AssignExternal VCA Fader Control Wiring Phase Reverse Stereo Effect Return ModuleCUT WidthHF EQ LF EQBAL MONO/STEREOVCA/MUTE Group Connectors and PIN Assignments Mono Subgroup Output Module CUE/SOLO Matrix MeterGroup Meter SUB/LCR Matrix Send PREConnectors and PIN Assignments Stereo Subgroup Output Module CUE/SOLO BAL Connectors and PIN Assignments LCR Subgroup Output Module Group Meters L, C, R VCA/MUTE Group 1 Assign Connectors and PIN Assignments Foldback Master Module 1 LevelHEADPHONES/HEADSET Outputs Headphones LevelAuxiliary Master Module AUX 1 LevelStereo Master Module Internal SINEWAVE/NOISE Generator OSCGENERATOR/TALKBACK Assign Matrix GroupsMonitor Section TapeMonitor Level DIMCUE Reset CUE/SOLO Master Section PFL/AFLTrim CUE IntlkTalkback System ToneLevel Comms onMaster Output Control PRE To MonoMono CUE/SOLO FadersMaster Connector Panel VCA Master Module Q2 Operationand Maintenance Manual BAL VCA Master Section CUT VCAConnectors and PIN Assignments Audio Master Module Q2 Technical Description Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Auxiliary Master Module Foldback Master Module Solo System Signal PathReset Circuit Q2 Operationand Maintenance Manual Q2 Panning ON/CUT Circuit Midi Interface Q2 Routing Input Module ResistorsInput Module Routing Links Level MeterInput Module Links Mono Group Output Module Mono Group Output Links Stereo Group Output Module Stereo Group Output LinksLCR Group Output Module LCR Group Output LinksQ2 VCA Input ModuleInput SUB Board Links Output SUB Board Links AdjustmentsOutput Module VCA Master Modules Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual