Telex Q II - FOH specifications Cables

Page 15

ATTENTION

CABLES

This product should only be used with high quality, screened twisted pair audio cables, terminated with metal bodied 3-pin XLR connectors. The cable shield should be connected to Pin 1. Any other cable type or configuration for the audio signals may result in degraded performance due to electromagnetic interference.

ELECTRIC FIELDS

Should this product be used in an electromagnetic field that is amplitude modulated by an audio frequency signal (20Hz - 20Khz), the signal to noise ratio may be degraded. Degradation of up to 60dB at a frequency corresponding to the modulation signal may be experienced under extreme conditions (3V/m, 90% modulation).

No permanent damage or degradation of performance will be caused by these conditions.

Q2 OPERATIONAND MAINTENANCE MANUAL 9601

15

Image 15

Contents II FOH Contents Declaration of Conformity Left Centre Right General InformationQ2 in USE Left Centre Right Effects Matrix Outputs Warranty Q2 Operationand Maintenance Manual Dimensions Distortion SpecificationsMaximum Gain Frequency ResponseQ2 Operationand Maintenance Manual Wiring Considerations Grounding Q2 Operationand Maintenance Manual Do not Disconnect the Mains Earth Cables Module Descriptions CUE Interlock Mode Master CUE Reset Matrix Section 20DB PAD Input Module Equaliser HI MIDLO MID PRE AuxiliariesDIR Routing and Status PAN MonoLCR Meter Mute Group CUEFader SafeInsert Send Connectors and PIN AssignmentsMIC Input Line InputVCA Input Module VCA/MUTE Group 1 Assign EXTExternal VCA Fader Control Wiring Width Phase ReverseStereo Effect Return Module CUTLF EQ HF EQMONO/STEREO BALVCA/MUTE Group Connectors and PIN Assignments Mono Subgroup Output Module Matrix Meter Group MeterCUE/SOLO Matrix Send PRE SUB/LCRConnectors and PIN Assignments Stereo Subgroup Output Module CUE/SOLO BAL Connectors and PIN Assignments LCR Subgroup Output Module Group Meters L, C, R VCA/MUTE Group 1 Assign Connectors and PIN Assignments 1 Level Foldback Master ModuleAUX 1 Level HEADPHONES/HEADSET OutputsHeadphones Level Auxiliary Master ModuleStereo Master Module Groups Internal SINEWAVE/NOISE GeneratorOSC GENERATOR/TALKBACK Assign MatrixDIM Monitor SectionTape Monitor LevelCUE Intlk CUE ResetCUE/SOLO Master Section PFL/AFL TrimComms on Talkback SystemTone LevelFaders Master Output Control PRETo Mono Mono CUE/SOLOMaster Connector Panel VCA Master Module Q2 Operationand Maintenance Manual BAL VCA VCA Master Section CUTConnectors and PIN Assignments Audio Master Module Q2 Technical Description Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Auxiliary Master Module Foldback Master Module Signal Path Reset CircuitSolo System Q2 Operationand Maintenance Manual Q2 Panning ON/CUT Circuit Midi Interface Input Module Resistors Q2 RoutingLevel Meter Input Module Routing LinksInput Module Links Mono Group Output Module Mono Group Output Links Stereo Group Output Links Stereo Group Output ModuleLCR Group Output Links LCR Group Output ModuleInput Module Q2 VCAInput SUB Board Links Adjustments Output ModuleOutput SUB Board Links VCA Master Modules Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual