Telex Q II - FOH specifications Matrix Meter, Group Meter, Cue/Solo

T/B

Enables talkback signals to be routed to the Matrix output when the communication system is used, with led indication. This can be used to prevent talkback signals going to unwanted destinations.

ON

Enables the Matrix output, with led indication.

MATRIX METER

Sub-panel preset used to calibrate the Matrix level meter.

GROUP METER

Sub-panel preset used to calibrate the Group level meter.

CUE/SOLO

Solo’s the Matrix signal to the main monitors (headphones or loudspeakers), with flashing led indication. See the Input Module for a functional description of the solo button.

FADER

The 60mm fader controls the level of the Matrix output signal.

PAN

Pans the Group signal across the main Stereo bus, or if in LCR mode across the Left, Right and Centre (mono) buses. In the centre, in L/R mode, the signals are 4.5dB below the signals when hard-panned left or right.

PAN (mode)

In the ‘up’ position the pan mode is conventional Stereo (L/R) panning. In the ‘down’ position, the group is panned across the three main outputs in Left-Centre-Right mode.

When the pan is fully anti-clockwise, signal is sent only to the left bus, with no signal to centre or right buses. In the centre, signal is sent only to the centre (mono) bus, with no signal to left or right buses.

When fully clockwise, signal is only sent to the right bus, with no signal sent to left or centre buses.

Q2 OPERATIONAND MAINTENANCE MANUAL 9601 37