Telex Q II - FOH specifications Monitor Section, Tape, Monitor Level, Dim

Page 52

MONITOR SECTION

Any of three sources may be fed to the monitoring section, in addition to the CUE/SOLO signal. If no source is selected, nothing is heard on monitors until a CUE/SOLO is pressed.

TAPE

Selects the Tape input as the monitor source.

L/R

Selects the main Stereo Left/Right output as the monitor source.

MONO

Selects the main Mono output as the monitor source.

If both L/R and MONO are pressed, monitoring is in true LCR mode, ie three channel outputs for simulation of the main speaker system. This facility is very useful when the console is located in a screened booth in a Theatre.

MONITOR LEVEL

Adjusts the level of the monitor outputs.

MONO

Assigns the monitor outputs to the mono (centre) monitor output.

DIM

Reduces the level of the monitoring system by 20dB.

ON

Enables the monitoring system.

Q2 OPERATIONAND MAINTENANCE MANUAL 9601

52

Image 52

Contents II FOH Contents Declaration of Conformity General Information Left Centre RightQ2 in USE Left Centre Right Effects Matrix Outputs Warranty Q2 Operationand Maintenance Manual Dimensions Specifications Maximum GainFrequency Response DistortionQ2 Operationand Maintenance Manual Wiring Considerations Grounding Q2 Operationand Maintenance Manual Do not Disconnect the Mains Earth Cables Module Descriptions CUE Interlock Mode Master CUE Reset Matrix Section 20DB PAD Input Module HI MID EqualiserLO MID Auxiliaries PREDIR Mono Routing and Status PANLCR Meter CUE FaderSafe Mute GroupConnectors and PIN Assignments MIC InputLine Input Insert SendVCA Input Module EXT VCA/MUTE Group 1 AssignExternal VCA Fader Control Wiring Phase Reverse Stereo Effect Return ModuleCUT WidthHF EQ LF EQBAL MONO/STEREOVCA/MUTE Group Connectors and PIN Assignments Mono Subgroup Output Module Group Meter Matrix MeterCUE/SOLO SUB/LCR Matrix Send PREConnectors and PIN Assignments Stereo Subgroup Output Module CUE/SOLO BAL Connectors and PIN Assignments LCR Subgroup Output Module Group Meters L, C, R VCA/MUTE Group 1 Assign Connectors and PIN Assignments Foldback Master Module 1 LevelHEADPHONES/HEADSET Outputs Headphones LevelAuxiliary Master Module AUX 1 LevelStereo Master Module Internal SINEWAVE/NOISE Generator OSCGENERATOR/TALKBACK Assign Matrix GroupsMonitor Section TapeMonitor Level DIMCUE Reset CUE/SOLO Master Section PFL/AFLTrim CUE IntlkTalkback System ToneLevel Comms onMaster Output Control PRE To MonoMono CUE/SOLO FadersMaster Connector Panel VCA Master Module Q2 Operationand Maintenance Manual BAL VCA Master Section CUT VCAConnectors and PIN Assignments Audio Master Module Q2 Technical Description Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Auxiliary Master Module Foldback Master Module Reset Circuit Signal PathSolo System Q2 Operationand Maintenance Manual Q2 Panning ON/CUT Circuit Midi Interface Q2 Routing Input Module ResistorsInput Module Routing Links Level MeterInput Module Links Mono Group Output Module Mono Group Output Links Stereo Group Output Module Stereo Group Output LinksLCR Group Output Module LCR Group Output LinksQ2 VCA Input ModuleInput SUB Board Links Output Module AdjustmentsOutput SUB Board Links VCA Master Modules Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual