Telex Q II - FOH specifications Stereo Group Output Module, Stereo Group Output Links

Page 78

THE STEREO GROUP OUTPUT MODULE

The stereo module is very similar to the mono group output but of course the signal paths must be duplicated. There are two group output signal paths and two matrix sends which can selected pre or post fader. The matrix returns are fed to ganged pots and the matrix output is again duplicated to give a stereo output.

Sub grouping to the L/R and Mono buses is done independently and there is a balance facility for the stereo sub signal. Soloing of the group and matrix signals is possible using identical circuitry to that described previously.

STEREO GROUP OUTPUT LINKS

Link	Function
1, 2	Group Bus Programming	**
3, 4	Matrix Send Programming	**
(7), 8	Post/Pre Mute Matrix Send
(207), 208	Post/Pre Mute Matrix Send R
11	Link for non VCA version
12, 13, (14)	Cut/On Lamp
(15), 16	Mute/Scene

**Installed link depends upon module position ( ) Factory Position

Q2 OPERATIONAND MAINTENANCE MANUAL 9601

78

Image 78

Contents II FOH Contents Declaration of Conformity General Information Left Centre RightQ2 in USE Left Centre Right Effects Matrix Outputs Warranty Q2 Operationand Maintenance Manual Dimensions Frequency Response SpecificationsMaximum Gain DistortionQ2 Operationand Maintenance Manual Wiring Considerations Grounding Q2 Operationand Maintenance Manual Do not Disconnect the Mains Earth Cables Module Descriptions CUE Interlock Mode Master CUE Reset Matrix Section 20DB PAD Input Module Equaliser HI MIDLO MID Auxiliaries PREDIR Routing and Status PAN MonoLCR Meter Safe CUEFader Mute GroupLine Input Connectors and PIN AssignmentsMIC Input Insert SendVCA Input Module EXT VCA/MUTE Group 1 AssignExternal VCA Fader Control Wiring CUT Phase ReverseStereo Effect Return Module WidthHF EQ LF EQBAL MONO/STEREOVCA/MUTE Group Connectors and PIN Assignments Mono Subgroup Output Module Matrix Meter Group MeterCUE/SOLO SUB/LCR Matrix Send PREConnectors and PIN Assignments Stereo Subgroup Output Module CUE/SOLO BAL Connectors and PIN Assignments LCR Subgroup Output Module Group Meters L, C, R VCA/MUTE Group 1 Assign Connectors and PIN Assignments Foldback Master Module 1 LevelAuxiliary Master Module HEADPHONES/HEADSET OutputsHeadphones Level AUX 1 LevelStereo Master Module GENERATOR/TALKBACK Assign Matrix Internal SINEWAVE/NOISE GeneratorOSC GroupsMonitor Level Monitor SectionTape DIMTrim CUE ResetCUE/SOLO Master Section PFL/AFL CUE IntlkLevel Talkback SystemTone Comms onMono CUE/SOLO Master Output Control PRETo Mono FadersMaster Connector Panel VCA Master Module Q2 Operationand Maintenance Manual BAL VCA Master Section CUT VCAConnectors and PIN Assignments Audio Master Module Q2 Technical Description Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Auxiliary Master Module Foldback Master Module Signal Path Reset CircuitSolo System Q2 Operationand Maintenance Manual Q2 Panning ON/CUT Circuit Midi Interface Q2 Routing Input Module ResistorsInput Module Routing Links Level MeterInput Module Links Mono Group Output Module Mono Group Output Links Stereo Group Output Module Stereo Group Output LinksLCR Group Output Module LCR Group Output LinksQ2 VCA Input ModuleInput SUB Board Links Adjustments Output ModuleOutput SUB Board Links VCA Master Modules Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual