Telex Q II - FOH specifications Cue/Solo

Page 41

T/B

Enables talkback signals to be routed to the Matrix output when the communication system is used, with led indication. This can be used to prevent talkback signals going to unwanted destinations.

ON

Enables the Matrix output, with led indication.

MATRIX METER (L and R)

Sub-panel preset used to calibrate the Stereo Matrix level meters.

GROUP METER (L and R)

Sub-panel preset used to calibrate the Stereo Group level meters.

CUE/SOLO

Solo’s the Stereo Matrix signal to the main monitors (headphones or loudspeakers), with flashing led indication. See the Input Module for a functional description of the solo button.

FADER

The 60mm fader controls the level of the Stereo Matrix output signals.

Q2 OPERATIONAND MAINTENANCE MANUAL 9601

41

Image 41

Contents II FOH Contents Declaration of Conformity Left Centre Right General InformationQ2 in USE Left Centre Right Effects Matrix Outputs Warranty Q2 Operationand Maintenance Manual Dimensions Maximum Gain SpecificationsFrequency Response DistortionQ2 Operationand Maintenance Manual Wiring Considerations Grounding Q2 Operationand Maintenance Manual Do not Disconnect the Mains Earth Cables Module Descriptions CUE Interlock Mode Master CUE Reset Matrix Section 20DB PAD Input Module LO MID EqualiserHI MID PRE AuxiliariesDIR LCR Routing and Status PANMono Meter Fader CUESafe Mute GroupMIC Input Connectors and PIN AssignmentsLine Input Insert SendVCA Input Module VCA/MUTE Group 1 Assign EXTExternal VCA Fader Control Wiring Stereo Effect Return Module Phase ReverseCUT WidthLF EQ HF EQMONO/STEREO BALVCA/MUTE Group Connectors and PIN Assignments Mono Subgroup Output Module CUE/SOLO Matrix MeterGroup Meter Matrix Send PRE SUB/LCRConnectors and PIN Assignments Stereo Subgroup Output Module CUE/SOLO BAL Connectors and PIN Assignments LCR Subgroup Output Module Group Meters L, C, R VCA/MUTE Group 1 Assign Connectors and PIN Assignments 1 Level Foldback Master ModuleHeadphones Level HEADPHONES/HEADSET OutputsAuxiliary Master Module AUX 1 LevelStereo Master Module OSC Internal SINEWAVE/NOISE GeneratorGENERATOR/TALKBACK Assign Matrix GroupsTape Monitor SectionMonitor Level DIMCUE/SOLO Master Section PFL/AFL CUE ResetTrim CUE IntlkTone Talkback SystemLevel Comms onTo Mono Master Output Control PREMono CUE/SOLO FadersMaster Connector Panel VCA Master Module Q2 Operationand Maintenance Manual BAL VCA VCA Master Section CUTConnectors and PIN Assignments Audio Master Module Q2 Technical Description Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual Auxiliary Master Module Foldback Master Module Solo System Signal PathReset Circuit Q2 Operationand Maintenance Manual Q2 Panning ON/CUT Circuit Midi Interface Input Module Resistors Q2 RoutingLevel Meter Input Module Routing LinksInput Module Links Mono Group Output Module Mono Group Output Links Stereo Group Output Links Stereo Group Output ModuleLCR Group Output Links LCR Group Output ModuleInput Module Q2 VCAInput SUB Board Links Output SUB Board Links AdjustmentsOutput Module VCA Master Modules Q2 Operationand Maintenance Manual Q2 Operationand Maintenance Manual