Bosch Appliances V1.0 operation manual 5Installation, DSP Matrix Mixer and Amplifiers

Page 13

PLENA matrix	Installation en 13

5Installation

Hardware and software installation procedures are described in the following chapters. Before installing the rack mounted products:

1.Set the mains power switch on the unit’s rear panel to the off position:

–The DSP matrix mixer unit and multi channel DSP amplifier operates on AC mains voltage ranging from 100‑240VAC, 50‑60Hz.

5.1	DSP Matrix Mixer and Amplifiers

The DSP matrix mixer and the multi channel DSP amplifiers are designed for installation into a 19" rack. For 19" rack installation; use:

–The 19" rack mounting brackets which come with the product.

–Standard M6 mounting screws: 16 mm thread depth, 20 mm total length.

Figure 5.1: 19” bracket and rack mounting

Notice!

If you install the product into a 19” rack:

-Ensure that it does not exceed the overheating temperature (+45°C ambient).

-Use the included Bosch 19” mounting brackets.

Bosch Security Systems B.V.

Operation manual

2013-06 V1.0

Image 13

Contents Plena matrix Page Table of contents Maintenance TroubleshootingTechnical Data Safety precautions 1Safety1FCC and Ices Business Equipment For commercial or professional useEn Safety Plena matrix About this manual Release date Documentation version Reason Document historyPLM-4P125 and PLM‑4P220 Multi channel DSP Amplifiers 3System overviewPLM‑8CS 8 Zone Call Station PC Configuration and User GUIPLM‑WCP Wall Control Panel Plena matrix System overview en 4Planning DSP Matrix Mixer and Amplifiers 5InstallationCall Station 3Wall Control Panel Refer to Wall Control Panel DIP switch settings,PC GUI software PC GUI application software installationPC requirements See also5iOS GUI software Wall Control Panel ConnectionsDescription Number Description Multi channel DSP AmplifierNumber Description Do not connect any device, other than a PLM‑4Px2x amplifier 4DSP Matrix MixerPanels DSP Matrix Mixer and Amplifiers, Call Station DIP switch settings 7ConfigurationCall station ID numbers DIP switch Wall Control Panel DIP switch settings 3Multi Channel DSP Amplifier settings Proceed as follows 4DSP matrix mixer PC GUIDSP matrix mixer GUI main screen DSP matrix mixer PC GUI control functions UserOther DSP matrix mixer configurations in the GUI DSP setupMulti Channel DSP Amplifier PC GUI Plena matrix Configuration en Amplifier GUI main screen Amplifier Bridging Configuration 1Start 8OperationContinue with one of the following chapters Continue with 2Call StationMaking an announcement Pre-settings and selectionsTop LED 0dB attenuation Select the input source Adjust the audio output volume levelWith DSP / PC GUI functionality Standalone without connection to the PC GUIActivate the amplifier auto standby Activate the active override audio input function3Operate the amplifier with the PC GUI RS485 LED 5DSP Matrix MixerActivate the Alert/EVAC override function 1Activate the override input function3Operating the DSP Matrix Mixer/system with the GUI Problem Possible cause Possible solution DSP matrix mixer or TroubleshootingCall stations / Wall Control Problem Possible cause Possible solutionCall station’s microphone 1Customer service 10.1 Clean the units Maintenance10.2 Clean air vents 10.3 Check the connectors and grounding11.1 Electrical Technical DataDSP Matrix Mixer Logic inputs Multi Channel DSP Amplifier8CS and WCP RS485 AmplifierConnectors 11.1.4 Wall Control Panel Call Station11.2.1 DSP Matrix Mixer 11.2 Mechanical11.2.3 Call Station 11.2.4 Wall Control Panel Standards 11.3 Environmental conditions11.3.1 DSP Matrix Mixer 11.3.3 Call StationPage Bosch Security Systems B.V