Bosch Appliances V1.0 operation manual Number Description

Page 20

20 en ConnectionsPLENA matrix

Number

Item

Description

 

 

 

 

10

Active

Contact closure to activate the “Override input”:

 

 

 

Use the 0 VDC from the sensor above as the common.

 

 

 

 

11

Network

RJ45 Ethernet communication socket:

 

 

 

Communication with the PLENA matrix GUI application.

 

 

 

 

 

Warning!

!The 12V DC power output (Auto Standby) connection should be only connected with products in accordance with recommendations outlined in this manual.

Notice!

Recommended motion sensors for use with the auto standby mode are the Bosch range of sensors.

For more information regarding Bosch security products contact your local Bosch Security certified partner or go to www.boschsecurity.com for details.

Notice!

It is recommended that the cable used Amp Link cable is a high quality STP CAT5 (e) cable. Amp Link cable distances should not exceed 5 meters per cable.

2013-06 V1.0

Operation manual

Bosch Security Systems B.V.

Image 20
Contents Plena matrix Page Table of contents Technical Data TroubleshootingMaintenance 1Safety Safety precautions1FCC and Ices Business Equipment For commercial or professional useEn Safety Plena matrix About this manual Document history Release date Documentation version Reason3System overview PLM-4P125 and PLM‑4P220 Multi channel DSP AmplifiersPLM‑WCP Wall Control Panel PC Configuration and User GUIPLM‑8CS 8 Zone Call Station Plena matrix System overview en 4Planning 5Installation DSP Matrix Mixer and AmplifiersCall Station Refer to Wall Control Panel DIP switch settings, 3Wall Control PanelPC GUI application software installation PC GUI softwarePC requirements See also5iOS GUI software Description ConnectionsWall Control Panel Multi channel DSP Amplifier Number DescriptionNumber Description Panels 4DSP Matrix MixerDo not connect any device, other than a PLM‑4Px2x amplifier DSP Matrix Mixer and Amplifiers, Call station ID numbers DIP switch 7ConfigurationCall Station DIP switch settings Wall Control Panel DIP switch settings 3Multi Channel DSP Amplifier settings 4DSP matrix mixer PC GUI Proceed as followsDSP matrix mixer PC GUI control functions User DSP matrix mixer GUI main screenMulti Channel DSP Amplifier PC GUI DSP setupOther DSP matrix mixer configurations in the GUI Plena matrix Configuration en Amplifier GUI main screen Amplifier Bridging Configuration Continue with one of the following chapters 8Operation1Start 2Call Station Continue withPre-settings and selections Making an announcementTop LED 0dB attenuation Adjust the audio output volume level Select the input sourceStandalone without connection to the PC GUI With DSP / PC GUI functionality3Operate the amplifier with the PC GUI Activate the active override audio input functionActivate the amplifier auto standby 5DSP Matrix Mixer RS485 LED3Operating the DSP Matrix Mixer/system with the GUI 1Activate the override input functionActivate the Alert/EVAC override function Troubleshooting Problem Possible cause Possible solution DSP matrix mixer orProblem Possible cause Possible solution Call stations / Wall ControlCall station’s microphone 1Customer service Maintenance 10.1 Clean the units10.2 Clean air vents 10.3 Check the connectors and groundingDSP Matrix Mixer Technical Data11.1 Electrical Multi Channel DSP Amplifier Logic inputs8CS and WCP RS485 AmplifierConnectors Call Station 11.1.4 Wall Control Panel11.2.3 Call Station 11.2 Mechanical11.2.1 DSP Matrix Mixer 11.2.4 Wall Control Panel 11.3 Environmental conditions Standards11.3.1 DSP Matrix Mixer 11.3.3 Call StationPage Bosch Security Systems B.V