METHODS OF BURNER IGNITION
There are two ways to ignite the burner. The first is by using the ignition system built into your grill. The second is with a match.
Next are the steps for igniting your grill using the ignition system. On the following page are steps for igniting your grill with a match.
Summary lighting instructions are on the right
BURNER IGNITION & USAGE
BURNER IGNITION
A) Open the grill lid (1).
mDANGER
Failure to open the lid before igniting the grill’s burner, or not waiting five minutes to allow the gas to clear if the grill does not light, may result in an explosive
B)Unfold the side tables (2) (Q® 1200, Q® 2000, Q® 2200).
C)Make sure the burner control knob is turned to the off
( ) position (3). Check by pushing burner control knob in and turning it clockwise until it stops.
D)Confirm that the cylinder is properly installed. Refer to
“INSTALLING THE LP CYLINDER.”
E)Push burner control knob in and turn it counterclockwise to start/high ( ) position (4).
F1) Push the red igniter button several times, so it clicks each time (5) (Q® 1000, Q® 2000).
OR
F2) Push and hold in the electronic igniter button (6) (Q® 1200, Q® 2200). You will hear the igniter clicking.
G)Check that the burner is lit by looking through the cooking grates. You should see a flame.
mWARNING: Do not lean over the open grill while igniting.
mWARNING: If burner fails to ignite within five seconds, stop, turn the burner control knob to off and wait five minutes to allow the gas to clear before you try again or light with a match.
TO EXTINGUISH BURNER
Push burner control knob in and turn it clockwise to the off ( ) position.
mCAUTION: Do not fold in side tables until grill is cold (Q® 1200, Q® 2000, Q® 2200).
Some batteries have a plastic protective wrap around them. This plastic must be removed before you attempt to ignite your grill. Do not confuse this plastic with the battery label.
14WWW.WEBER.COM®