Rangemaster U109600-02 manual Griddle, Glide-out Grill

Page 19

To ﬁt the small inner burner, ﬁnd the larger electrode notch in the burner rim. Line this up with the white ignition electrode and place the inner burner on the large base ring.

A - Electrode notch, B - Ignition electrode

Now ﬁt the two trim rings, making sure that they are sitting down properly.

Griddle

Always clean the griddle after use. Allow to cool completely before removing. Immerse the griddle plate in hot soapy water. Use a soft cloth or, for stubborn stains, a nylon washing up brush.

NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS THESE WILL DAMAGE THE SURFACE.

Glide-out™ Grill

Before you remove any of the grill parts for cleaning make sure that they are cool.

The grill pan and grid should be washed in hot soapy water. After grilling meats or any foods that soil, leave to soak for a few minutes in the sink immediately after use. Stubborn particles may be removed from the grid by using a nylon brush. Alternatively the grill pan can be washed in a dish washer.

To remove the grill pan support frame, pull the grill pan forward.

Lift the grill pan clear of the support frame.

The support frame is held to the side rails by two clips on each side.

For each side, support the side rail with one hand and with the other hand lift the frame up and out of the side clips.

For safety, push the side rails back into the grill chamber.

The side rails can be removed to make cleaning the grill chamber easer by unhooking them from the grill chamber sides.

Slides can be wiped clean with soft cloth and mild detergent.

19

Image 19

Contents Dual Fuel Gas and Electricity on InstallationThis appliance should not be installed in a boat or caravan Be safeContents Hotplate Burners High/medium GriddleMedium/low Wok cradle Care and CleaningEssential information Never close the grill door when the grill is on Using the grillGlide-out Grill Left Hand Oven Right Hand Fan Oven OvensTo time something that’s cooking minute minder Setting the time of dayTo stop the beeper when it sounds ClockTo activate the key lock Auto is showing, you want to reset to manual cookingClock Special Features Key Lock To start & stop the oven automaticallyBoth Ovens Cooking using the timerMulti-function oven functions Multi-function ovenConventional oven top and base heat HandyrackOven light Oven shelvesStorage Food Cooking chart Fan assisted oven functionMulti-function Oven cooking guide Ensure meat and poultry is fully cooked before servingFish Oven Cooking chart Conventional and full Fan oven functionsWok burners Cleaning your cookerHotplate burners Central hotplateGlide-out Grill GriddleOven and Grill Cleaning Table HotplatePart Finish Recommended Cleaning Method Outside of cookerDo not put the side runners in a dishwasher Control Panel and DoorsOvens Removing the Oven LiningsTo refit the draw Moving your cookerTroubleshooting Oven light is not working Oven temperature getting hotter as the cooker gets olderHotplate ignition or hotplate burners faulty Grill not cooking properly0800 111 General Safety InstructionsThis appliance is heavy, take care when moving it Location of Cooker InstallationDear Installer Provision of VentilationYou will also need the following tools Checking the partsUnpacking the Cooker Positioning the CookerMoving the Cooker Fit the Handles LevellingHandles should be above the ﬁxings Gas Connection Pressure testingFitting the splash back Fitting a stability bracketFitting the plinth Electrical ConnectionGrill Oven checkStick on label Tap adjustmentConversion to LP gas JetsServicing Notes To Change a Hotplate Tap To Remove a ThermostatTo Remove or Change a Hotplate Burner To Change Grill ControllerTo Change Oven Door Seal To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door CatchTo Remove Grill Element To Replace an Oven FanTo Remove the left hand Oven Bottom and Top Elements To Remove an Oven fan ElementCircuit Diagram Connections Technical DataDimensions This cooker is category II2H3+