Rangemaster U109600-02 manual To Change Oven Door Outer Panel, To Change Oven Door Catch

Rangemaster U109600-02 manual Oven Cooking chart Conventional and full Fan oven functions, Fish Rangemaster U109600-02 manual Cleaning your cooker, Hotplate burners, Central hotplate, Wok burners Rangemaster U109600-02 manual Griddle, Glide-out Grill Rangemaster U109600-02 Cleaning Table Hotplate, Outside of cooker, Oven and Grill, Part Finish Recommended Cleaning Method Rangemaster U109600-02 manual Control Panel and Doors, Ovens, Removing the Oven Linings Rangemaster U109600-02 manual Moving your cooker, To refit the draw Rangemaster U109600-02 manual Troubleshooting Rangemaster U109600-02 manual Oven temperature getting hotter as the cooker gets older, Grill not cooking properly Rangemaster U109600-02 manual General Safety Instructions, 0800 111 Rangemaster U109600-02 manual This appliance is heavy, take care when moving it Rangemaster U109600-02 manual Installation, Dear Installer, Provision of Ventilation, Location of Cooker, Conversion Rangemaster U109600-02 manual Checking the parts, You will also need the following tools
Rangemaster U109600-02 manual Positioning the Cooker, Unpacking the Cooker, Moving the Cooker
Rangemaster U109600-02 manual Levelling, Fit the Handles, Handles should be above the fixings
Rangemaster U109600-02 manual Fitting the splash back, Fitting a stability bracket, Gas Connection, Pressure testing
Rangemaster U109600-02 manual Electrical Connection, Grill, Oven check, Fitting the plinth, Refit the draw, Customer care
Rangemaster U109600-02 manual Conversion to LP gas, Jets, Stick on label, Tap adjustment
Rangemaster U109600-02 manual Servicing Notes
Rangemaster U109600-02 manual To Remove a Thermostat, To Remove or Change a Hotplate Burner, To Change Grill Controller
Rangemaster U109600-02 manual To Change Oven Door Outer Panel, To Change Oven Door Catch, To Adjust Oven Door Catch Keep
Rangemaster U109600-02 manual To Replace an Oven Fan, To Remove the left hand Oven Bottom and Top Elements
Rangemaster U109600-02 manual Circuit Diagram
Rangemaster U109600-02 manual Technical Data, This cooker is category II2H3+, Dimensions, Connections, Ratings
Rangemaster U109600-02 manual
Page 36

SERVICING - WARNING

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

15. To Change Oven Door Outer Panel

Remove the two plastic blanking plugs from the door handles. Remove the 4mm Hex headed screws holding the handle to the door with the hexagon key tool. Remove two screws from top edge and two from bottom edge of the door.

Remove outer door panel. Fit door handle to new panel. Fit the plastic blanking plugs to the fixing holes.

The handles should be above the fixings.

Fit panel to door. If replacing the outer panel on the right hand door (with the Thermodial) take care to make sure the sensor of the Thermodial is sealed to the door by the rubber grommet.

������

������

�������

 

ArtNo.320-0029 - Thermodial

Reassemble in reverse order.

16. To Change Oven Door Catch

Remove outer door panel (see 15). Remove screws ‘B’ holding catch assembly to inner door panel. Fit new catch and reassemble in reverse order.

Check correct door operation.

17. To Adjust Oven Door Catch Keep

Open oven door, slacken off locknut at base of keep, and screw in or out as required until required fit is obtained.

Retighten locking nut.

18. To Change Oven Door Seal

Open oven door. The seal is held in place by small hooks on the rear face. At the corner pull seal diagonally away from the door centre until that hook is released. Proceed to the next hook and release it in a similar way, and so on.

When fitting new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door snapping in each hook in turn.

19. To Change Ignition Generator

Disconnect from electricity supply.

Pull cooker forward to gain access to the cover box at the rear of the left hand cooker. Remove the screws securing the cover and lift clear. Pull off all the leads to the generator noting their positions. Slacken the two screws holding generator to cooker and remove generator.

Fit new generator to cooker and replace leads. Reassemble in reverse order. Refer to wiring diagram. Check ignition performance.

20. To Remove Oven Inner Back.

Open the oven door. Remove oven furniture. For the left hand oven unscrew the 2 thermostat phial fixing screws.

36

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Dual Fuel Installation This appliance should not be installed in a boat or caravanBe safe Gas and Electricity onContents Hotplate Burners Griddle High/mediumMedium/low Care and Cleaning Wok cradleEssential information Using the grill Never close the grill door when the grill is onGlide-out Grill Ovens Left Hand Oven Right Hand Fan OvenSetting the time of day To stop the beeper when it soundsClock To time something that’s cooking minute minderAuto is showing, you want to reset to manual cooking Clock Special Features Key LockTo start & stop the oven automatically To activate the key lockCooking using the timer Both OvensMulti-function oven Multi-function oven functionsHandyrack Conventional oven top and base heatOven shelves Oven lightStorage Cooking chart Fan assisted oven function Multi-function Oven cooking guideEnsure meat and poultry is fully cooked before serving FoodOven Cooking chart Conventional and full Fan oven functions FishCleaning your cooker Hotplate burnersCentral hotplate Wok burnersGriddle Glide-out GrillCleaning Table Hotplate Part Finish Recommended Cleaning MethodOutside of cooker Oven and GrillControl Panel and Doors OvensRemoving the Oven Linings Do not put the side runners in a dishwasherMoving your cooker To refit the drawTroubleshooting Oven temperature getting hotter as the cooker gets older Hotplate ignition or hotplate burners faultyGrill not cooking properly Oven light is not workingGeneral Safety Instructions 0800 111This appliance is heavy, take care when moving it Installation Dear InstallerProvision of Ventilation Location of CookerChecking the parts You will also need the following toolsPositioning the Cooker Unpacking the CookerMoving the Cooker Levelling Fit the HandlesHandles should be above the fixings Pressure testing Fitting the splash backFitting a stability bracket Gas ConnectionElectrical Connection GrillOven check Fitting the plinthTap adjustment Conversion to LP gasJets Stick on labelServicing Notes To Remove a Thermostat To Remove or Change a Hotplate BurnerTo Change Grill Controller To Change a Hotplate TapTo Adjust Oven Door Catch Keep To Change Oven Door Outer PanelTo Change Oven Door Catch To Change Oven Door SealTo Replace an Oven Fan To Remove the left hand Oven Bottom and Top ElementsTo Remove an Oven fan Element To Remove Grill ElementCircuit Diagram Technical Data DimensionsThis cooker is category II2H3+ Connections
Top Page Image Contents