Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be required to move it.
First remove the drawer. Pull it right out and lift up the ends of the plastic clips (one each side) to release the catches holding the drawer to the side runners and at the same time pull the drawer forward and away from the side runners.
Open the grill door and right hand oven door so that you can get a good grip on the bottom of the control panel as you move the oven.
Do not move the oven by pulling the hand rail, door handles or knobs.
Move the oven a bit at a time, checking behind it to make sure the gas hose is not caught. Make sure both electricity and gas cables have sufficient slack to move the cooker forward as you go along.
For safety’s sake push the drawer runners back out of the way.
There are also two screw down levelling feet at the front of the cooker. The cooker is also fitted with one roller at the front and two at the back. In normal use the front roller, designed for moving the cooker, is raised so that the front feet support the cooker. The levelling tool that controls this roller should be in the storage drawer. If you cannot find the levelling tool, contact your installer (see the start of the ‘Installation’ section of these instructions).
Locate levelling tool as shown.
Turn the levelling tool clockwise, two full (180°) turns. It will be stiff. The front of the oven will rise slightly as the roller drops down.
If a stability chain is fitted, release it as you ease the cooker out.
When you replace the cooker, wind it down off the front roller by turning the levelling tool anti- clockwise. This is important. It will stop the cooker moving accidentally, while in use.
To refit the draw
To replace the drawer in the cooker, pull the side rails fully out. Carefully move the drawer back between the rails and rest it on the side rails.
At each side hold the front of the drawer and pull the side rail forward so that the clips click into position holding the drawer to the side rails.
22