Rangemaster U109600-02 manual To Remove a Thermostat, To Remove or Change a Hotplate Burner

Page 35

SERVICING - WARNING

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

7. To Remove A Thermostat

Remove control panel (see 2) and cooktop (see 3). Open the appropriate oven door and remove the oven shelves.

Right hand oven

Remove oven roof. Remove the two fixings that secure the thermostat phial cover. Unclip the thermostat phial from the clips in the oven back panel & remove from the top rear of the oven.

12. To Remove or Change a Hotplate Burner.

Remove the cooktop tray (see 3).

Centre Hotplate burners

Remove the control panel (see 2). The burners are mounted in 2’s on cross supports. Disconnect the burner feed pipes at the burners. Remove the screw at the front holding the cross support. Slide the support to the right to release in from the rear location.

Left hand oven

Remove the two screws holding the thermostat phial to the oven fan cover at the rear of the oven. Pull the unit forward to access the rear of the cooker. Remove both rear cover boxes by removing the fixing screws and lifting clear. Feed the thermostat capillary clear of the oven. Disconnect the wires from the thermostat and undo the two fixings that secure the control to the mounting plate. Fit the replacement and re-assemble in reverse order. Ensure that the phial is clipped to the oven rear, positioned centrally between the clips. Check that the thermostat functions correctly.

8. To Change Grill Controller

Remove the control panel (see 2) and cooktop (see 3). Disconnect wiring from controller. Remove 2 screws holding switch/controller to mounting panel. Fit new controller and reassemble in reverse order. Check for correct operation.

BEFORE SERVICING ANY GAS CARRYING COMPONENTS TURN OFF GAS SUPPLY.

Lift the cross support and burners clear. The burners are fixed to the cross supports with screws underneath Remove the appropriate burner and fit the new one. Reassemble in reverse order. Check burner operation is satisfactory.

Wok burners

Disconnect the burner feed pipes at the burner. Fit the new one and reassemble in reverse order. Check burner operation is satisfactory.

9. To Change a Hotplate Tap

Remove the cooktop top, see 3. Undo the nut at rear of the valve and remove the screw(s) securing valve to gas rail. Remove old valve, discard old gasket/seal. Fit new gasket/ seal to new valve.

Reassemble in reverse order. Check valve is adjusted for correct gas. Check cooker is gas sound.

10. To Change a Hotpate burner jet

Remove burner cap and head. Remove old jet. Fit new orifice. Note the Wok burner has 2 orifices. Reassemble in reverse order. Check appliance is gas sound.

11. To Change Hotplate Burner Electrode

Lift off cooktop pan supports, remove burner cap. Remove the screw holding the electrode. Pull electrode vertically up sufficiently to grip the lead between thumb and forefinger. Pull off the electrode, but keep hold of the lead. Fit new electrode to the lead. Fix electrode in burner with screw. Replace burner cap. Check the burner ignition. Replace pan supports.

13. To Remove Grill Outer Door Panel

Open left hand oven door and remove 2 screws from bottom edge of grill door. Open grill door, support grill door outer panel and remove two screws from top inner face of grill door.

Reassemble in reverse order.

14. To Remove an Oven Door

Open oven door and remove Handyrack (where fitted) by springing one side out of the bracket on the door and sliding the other side free.

Door is heavy - take care. Open the oven door. Loosen the two top hinge screws.

ArtNo.320-0001 Door hinges

Support the weight of the door and remove the screw nearest the hinge pin. Swing the hinge up and away from the hinge pin on the door.

Lift the door away from the bottom hinge. Re-assemble in reverse order.

When replacing the door ensure that the nylon hinge bush is in position between the hinge pin and the hinge bracket at the both the bottom and top.

35

Image 35
Contents Dual Fuel Gas and Electricity on InstallationThis appliance should not be installed in a boat or caravan Be safeContents Hotplate Burners Medium/low GriddleHigh/medium Essential information Care and CleaningWok cradle Glide-out Grill Using the grillNever close the grill door when the grill is on Left Hand Oven Right Hand Fan Oven OvensTo time something that’s cooking minute minder Setting the time of dayTo stop the beeper when it sounds ClockTo activate the key lock Auto is showing, you want to reset to manual cookingClock Special Features Key Lock To start & stop the oven automaticallyBoth Ovens Cooking using the timerMulti-function oven functions Multi-function ovenConventional oven top and base heat HandyrackOven light Oven shelvesStorage Food Cooking chart Fan assisted oven functionMulti-function Oven cooking guide Ensure meat and poultry is fully cooked before servingFish Oven Cooking chart Conventional and full Fan oven functionsWok burners Cleaning your cookerHotplate burners Central hotplateGlide-out Grill GriddleOven and Grill Cleaning Table HotplatePart Finish Recommended Cleaning Method Outside of cookerDo not put the side runners in a dishwasher Control Panel and DoorsOvens Removing the Oven LiningsTo refit the draw Moving your cookerTroubleshooting Oven light is not working Oven temperature getting hotter as the cooker gets olderHotplate ignition or hotplate burners faulty Grill not cooking properly0800 111 General Safety InstructionsThis appliance is heavy, take care when moving it Location of Cooker InstallationDear Installer Provision of VentilationYou will also need the following tools Checking the partsMoving the Cooker Positioning the CookerUnpacking the Cooker Handles should be above the fixings LevellingFit the Handles Gas Connection Pressure testingFitting the splash back Fitting a stability bracketFitting the plinth Electrical ConnectionGrill Oven checkStick on label Tap adjustmentConversion to LP gas JetsServicing Notes To Change a Hotplate Tap To Remove a ThermostatTo Remove or Change a Hotplate Burner To Change Grill ControllerTo Change Oven Door Seal To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door CatchTo Remove Grill Element To Replace an Oven FanTo Remove the left hand Oven Bottom and Top Elements To Remove an Oven fan ElementCircuit Diagram Connections Technical DataDimensions This cooker is category II2H3+