Rangemaster U109600-02 manual Servicing Notes

Page 34

SERVICING - WARNING

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Servicing Notes

When servicing or replacing gas carrying components disconnect from gas before commencing operation and check appliance is gas sound after completion. When checking for gas leaks use a liquid leak detector at all joints and connections to check for leaks in the system.

When checking for gas leaks do not use washing up liquid

-this can corrode. Use a product specifically manufactured for leak detection. In GB refer to BS 6891.

After completing the gas connection, check the cooker is gas sound with a pressure test.

Leak testing of the appliance shall be conducted in accordance to the manufacturer’s instructions.

CAUTION: DO NOT USE A FLAME TO CHECK FOR GAS LEAKS.

Do not use re-conditioned or unauthorised gas controls.

Disconnect from electricity supply before commencing servicing, particularly before removing any of the following: control panel, side panels, cooktop tray, or any of the electrical components or cover boxes. Before electrical reconnection check that the appliance is electrically safe.

1. To Remove the Hand Rail

Remove the handrail plastic blanking plugs and remove the 2 end bracket fixing screws.

2. To Remove Control Panel

Disconnect from electricity supply.

Pull off all the control knobs. Remove the hand rail (see 2) Remove the 2 cross headed screws that were hidden by the hand rail end brackets.

Open the grill door and right hand oven door and remove the 2 screws underneath the control panel.

Pull the control panel forward and support so that the wires are not strained.

Reassemble in reverse order. When replacing leads refer to the wiring diagram. Check operation of timer, ignition, and oven light switches.

3. To Remove the Hotplate top

Disconnect from electricity supply.

Remove the pan supports, cooktop burner caps and tops. If there are screws holding the cooktop burners to the cooktop, remove them (not the spark electrode fixing screws).

A - Cooktop front fixing screws,

B - Cooktop rear fixing screws (on cooker back)

Remove the 2 rear cooktop fixing screws (B) on cooker back under the flue grille and the 4 front cooktop fixing screws

(A).

Remove the screws holding the flue grille stays.

Lift the cooktop clear of the appliance. Replace in reverse order.

Reassemble in reverse order ensuring that the leads are reconnected.

Check for correct burner operation.

4. To Remove a Side Panel

Disconnect from electricity supply.

Remove control panel (see 2). Pull the cooker forward. Remove the 4 retaining screws for each panel (2 at the front and 2 at the rear). The lower front retaining screws (one each side) are situated beneath the lower edge at the front corners of the side panels

Reassemble in reverse order.

5. To Remove Oven Light Switch

Remove control panel (see 2).

NB The old switch may be destroyed during removal.

Remove switch button and old switch from its bezel by gripping the switch body behind the control panel and twisting sharply.

The switch bezel can then be removed by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the cutout in the control panel and pushing it in from the front. Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.

Replace control panel in reverse order and test for correct operation.

6. To Remove Electronic Timer

Disconnect from electricity supply.

Pull off the timer control buttons and remove the control panel (See 2). Remove the timer/mounting bracket assembly from the control panel by removing the two fixing screws. Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.

Reassemble in reverse order. When replacing leads refer to the wiring diagram. Check operation of timer.

34

Image 34
Contents Dual Fuel Be safe InstallationThis appliance should not be installed in a boat or caravan Gas and Electricity onContents Hotplate Burners High/medium GriddleMedium/low Wok cradle Care and CleaningEssential information Never close the grill door when the grill is on Using the grillGlide-out Grill Ovens Left Hand Oven Right Hand Fan OvenClock Setting the time of dayTo stop the beeper when it sounds To time something that’s cooking minute minderTo start & stop the oven automatically Auto is showing, you want to reset to manual cookingClock Special Features Key Lock To activate the key lockCooking using the timer Both OvensMulti-function oven Multi-function oven functionsHandyrack Conventional oven top and base heatOven shelves Oven lightStorage Ensure meat and poultry is fully cooked before serving Cooking chart Fan assisted oven functionMulti-function Oven cooking guide FoodOven Cooking chart Conventional and full Fan oven functions FishCentral hotplate Cleaning your cookerHotplate burners Wok burnersGriddle Glide-out GrillOutside of cooker Cleaning Table HotplatePart Finish Recommended Cleaning Method Oven and GrillRemoving the Oven Linings Control Panel and DoorsOvens Do not put the side runners in a dishwasherMoving your cooker To refit the drawTroubleshooting Grill not cooking properly Oven temperature getting hotter as the cooker gets olderHotplate ignition or hotplate burners faulty Oven light is not workingGeneral Safety Instructions 0800 111This appliance is heavy, take care when moving it Provision of Ventilation InstallationDear Installer Location of CookerChecking the parts You will also need the following toolsUnpacking the Cooker Positioning the CookerMoving the Cooker Fit the Handles LevellingHandles should be above the fixings Fitting a stability bracket Pressure testingFitting the splash back Gas ConnectionOven check Electrical ConnectionGrill Fitting the plinthJets Tap adjustmentConversion to LP gas Stick on labelServicing Notes To Change Grill Controller To Remove a ThermostatTo Remove or Change a Hotplate Burner To Change a Hotplate TapTo Change Oven Door Catch To Adjust Oven Door Catch KeepTo Change Oven Door Outer Panel To Change Oven Door SealTo Remove an Oven fan Element To Replace an Oven FanTo Remove the left hand Oven Bottom and Top Elements To Remove Grill ElementCircuit Diagram This cooker is category II2H3+ Technical DataDimensions Connections