Rangemaster U109600-02 manual Control Panel and Doors, Ovens, Removing the Oven Linings

Page 21

Do not use any abrasive substance.

DO NOT put the side runners in a dishwasher

When you have finished, hook the side rails back onto the sides of the chamber. To refit the frame pull the side rails forward and for each side in turn support the side rail and press the frame down into the side rails. Replace the grill pan.

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners, e.g. Cif, on brushed Stainless Steel surfaces. For best results use a liquid detergent e.g. Domestos Multi Surface Cleaner.

The control panel and control knobs should only be cleaned with a soft cloth wrung out in clean hot soapy water. Wipe with a clean dampened cloth then polish with a dry cloth. The oven doors should only be cleaned with a soft cloth wrung out in clean hot soapy water.

Removing the Oven Linings

Some of the lining panels can be removed for cleaning and for cleaning behind. Remove the shelves first.

On some models the right hand fanned oven has a removable oven roof - if fitted slide the roof liner forward and remove.

The side panels of either oven can be removed.

Each side of the oven is fixed with four fixing screws. You don’t have to remove the screws to remove the oven linings. Lift each side panel upwards and they will slide off the screws. Then pull them forwards.

Ovens

The ovens have removable panels that have been coated with a special enamel that partly cleans itself. This does not stop all marks on the lining, but helps to reduce the amount of manual cleaning needed.

The Cook & Clean panels work better above 200°C. If you do most of your cooking below this temperature, occasionally remove the panels and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at 200°C for about one hour. This will ensure the Cook & Clean panels are working effectively.

Don’t use steel wool (Brillo) or any other materials that will scratch the surface. Don’t use oven cleaning pads.

Once the linings are removed, the oven enamel interior can be cleaned.

When replacing the linings fit the side linings first.

Make sure you fit the oven roof with the slot at the front.

21

Image 21
Contents Dual Fuel This appliance should not be installed in a boat or caravan InstallationBe safe Gas and Electricity onContents Hotplate Burners Griddle High/mediumMedium/low Care and Cleaning Wok cradleEssential information Using the grill Never close the grill door when the grill is onGlide-out Grill Left Hand Oven Right Hand Fan Oven OvensTo stop the beeper when it sounds Setting the time of dayClock To time something that’s cooking minute minderClock Special Features Key Lock Auto is showing, you want to reset to manual cookingTo start & stop the oven automatically To activate the key lockBoth Ovens Cooking using the timerMulti-function oven functions Multi-function ovenConventional oven top and base heat HandyrackOven light Oven shelvesStorage Multi-function Oven cooking guide Cooking chart Fan assisted oven functionEnsure meat and poultry is fully cooked before serving FoodFish Oven Cooking chart Conventional and full Fan oven functionsHotplate burners Cleaning your cookerCentral hotplate Wok burnersGlide-out Grill GriddlePart Finish Recommended Cleaning Method Cleaning Table HotplateOutside of cooker Oven and GrillOvens Control Panel and DoorsRemoving the Oven Linings Do not put the side runners in a dishwasherTo refit the draw Moving your cookerTroubleshooting Hotplate ignition or hotplate burners faulty Oven temperature getting hotter as the cooker gets olderGrill not cooking properly Oven light is not working0800 111 General Safety InstructionsThis appliance is heavy, take care when moving it Dear Installer InstallationProvision of Ventilation Location of CookerYou will also need the following tools Checking the partsPositioning the Cooker Unpacking the CookerMoving the Cooker Levelling Fit the HandlesHandles should be above the fixings Fitting the splash back Pressure testingFitting a stability bracket Gas ConnectionGrill Electrical ConnectionOven check Fitting the plinthConversion to LP gas Tap adjustmentJets Stick on labelServicing Notes To Remove or Change a Hotplate Burner To Remove a ThermostatTo Change Grill Controller To Change a Hotplate TapTo Change Oven Door Outer Panel To Adjust Oven Door Catch KeepTo Change Oven Door Catch To Change Oven Door SealTo Remove the left hand Oven Bottom and Top Elements To Replace an Oven FanTo Remove an Oven fan Element To Remove Grill ElementCircuit Diagram Dimensions Technical DataThis cooker is category II2H3+ Connections