Hearth and Home Technologies CARDOG36IL Pilot Shield, Install Lava Rock, Positioning the Logs

Page 18

8 Appliance Setup
A. Clean the Appliance
Clean/vacuum any material that may have accumulated
inside the ﬁrebox.
B. Optional Accessories
Install approved accessories per instructions included with
accessories. Contact your dealer for a list of approved ac-
cessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional accesso-
ries with this appliance. Using non-listed accessories could
result in a safety hazard and will void the warranty.	Figure 8.2 Install Lava Rock

C. Pilot Shield

Ensure the pilot shield is still in the position shown in the photo below. Shipping could cause it to become displaced.

HEAT

SHIELD

PILOT

SHIELD

PILOT

BRACKET

Figure 8.1 Pilot Shield Position

D. Install Lava Rock

Pour lava rock into the burner pan and cover the burner tube. DO NOT cover the burner tube from the right grate support to the pilot assembly. See Figure 8.2 & 8.3. There is extra rock provided to cover the front of the ﬁrebox if desired.

NOTICE! Do not cover area around pilot assembly with lava rock. Too much rock will interfere with pilot ﬂame ignition, rectiﬁcation, and wind stability.

NO LAVA ROCK IN THIS AREA

Figure 8.3 Install Lava Rock

E. Positioning the Logs

CAROLINA-36

•Place the rear log on the shelf against the appliance rear wall. Position log as far back on the shelf as possible.

PUSH LOG TO BACK OF SHELF

Figure 8.4 Place Rear Log - Carolina-36

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11

18

Image 18

Contents CARODG36I CARODG36IL CARODG42I CARODG42IL Congratulations Listing Label Information/LocationTable of Contents Listing and Code Approvals Getting Started Design and Installation ConsiderationsIf this ﬁreplace is to be installed within a wall, you must Tools and Supplies NeededFraming and Clearances Stand-Alone InstallationBuilt-in Installation Select Appliance LocationClearances and Framing Dimensions CARODG36I, CARODG36IL 1448 mm MinimumNot be placed between Fireplace opening Ceiling/overhang Fireplace Flashing Appliance PreparationSecuring and Leveling Appliance Position, level, and secure the applianceFuel Conversion Control Box Access PanelGas Information Gas PressureValve Access Connect Incoming Gas Line to Manual Shutoff ValveIntelliFire Plus Pilot Ignition System Wiring Electrical InformationNine Hour Safety Shutdown Feature Control Module OperationInstalling the Optional Electric Kit Match holesWire the GFI receptacle as shown below Assemble the junction boxMantel Projections Facing MaterialInstall Lava Rock Pilot ShieldPositioning the Logs Notch against grate CAROLINA-42 Place Remaining Lava Rock Place left center log in the indentations on the front leftLog and the top left log as shown in Figure Install Firescreen Insert RodYour Fireplace Screens Gas Fireplace SafetyOperating Instructions Before Lighting FireplaceLighting the Appliance Final inspection byInitial Break-in Procedure After the Appliance is LitTroubleshooting IntelliFire Plus Ignition SystemTroubleshooting Symptom Possible Cause Corrective ActionMaintaining and Servicing the Appliance Risk of injury or property damage Before servicingMaintenance and Service Tasks Inspect Maintenance TasksAppliance Dimension Diagram Reference MaterialsCARODG42I, CARODG42IL #15 Non Combustible Board Log Set AssemblyService Parts List Part number list on followingStocked At DepotCARODG42I, CARODG42IL #14 Non Combustible BoardTouch up Paint, Fiber Additional service part numbers appear on followingPatch Kit, Fiber Conversion Kit NG#15 Valve Assembly Warranty Outdoor Lifestyles Warranty 2108-975A 10/05/09Limitations of Liability Contact Information