Hearth and Home Technologies CARDOG36IL Reference Materials, Appliance Dimension Diagram

Page 30

12 Reference Materials

A. Appliance Dimension Diagram

Dimensions are actual appliance dimensions. Use for reference only. For framing dimensions and clearances refer to Section 3.

CARODG36I, CARODG36IL
	44 in.
	(1118 mm)
15-1/2 in.	TOP VIEW	15 in.
(394 mm)		(381 mm)
	STANDOFFS CAN BE REMOVED
	IF NOT INSTALLED IN A WALL	NON-COMBUSTIBLE BOARD
		NON-COMBUSTIBLE BOARD
			11-1/2 in.	42-1/2 in.
			11-1/2 in.	(1080 mm)
			(292 mm)	(1080 mm)
			(292 mm)
28-7/8 in.		9-1/2 in.		36-1/2 in.
(734 mm)		9-1/2 in.		(927 mm)
		(241 mm)
			10 in.
			(254 mm)
	33-3/8 in.
	(848 mm)	2-1/4 in.
		(57 mm)
	FRONT	6 in.
		6 in.
		(152 mm)
	5-1/8 in.
	(130 mm)	6 in.
		6 in.
	BOTTOM VIEW	(152 mm)
	BOTTOM VIEW
		3/4 in.
		(19 mm)
	GAS ACCESS LOCATION ON APPLIANCE
IF CONTROL BOX IS LOCATED ON SIDE OF APPLIANCE
Figure 12.1 Appliance Dimensions - CARODG36I, CARODG36IL

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11

30

Image 30

Contents CARODG36I CARODG36IL CARODG42I CARODG42IL Congratulations Listing Label Information/LocationTable of Contents Listing and Code Approvals Getting Started Design and Installation ConsiderationsIf this ﬁreplace is to be installed within a wall, you must Tools and Supplies NeededFraming and Clearances Stand-Alone InstallationBuilt-in Installation Select Appliance LocationClearances and Framing Dimensions CARODG36I, CARODG36IL 1448 mm MinimumNot be placed between Fireplace opening Ceiling/overhang Fireplace Flashing Appliance PreparationSecuring and Leveling Appliance Position, level, and secure the applianceFuel Conversion Control Box Access PanelGas Information Gas PressureValve Access Connect Incoming Gas Line to Manual Shutoff ValveIntelliFire Plus Pilot Ignition System Wiring Electrical InformationNine Hour Safety Shutdown Feature Control Module OperationInstalling the Optional Electric Kit Match holesWire the GFI receptacle as shown below Assemble the junction boxMantel Projections Facing MaterialInstall Lava Rock Pilot ShieldPositioning the Logs Notch against grate CAROLINA-42 Place Remaining Lava Rock Place left center log in the indentations on the front leftLog and the top left log as shown in Figure Install Firescreen Insert RodYour Fireplace Screens Gas Fireplace SafetyOperating Instructions Before Lighting FireplaceLighting the Appliance Final inspection byInitial Break-in Procedure After the Appliance is LitTroubleshooting IntelliFire Plus Ignition SystemTroubleshooting Symptom Possible Cause Corrective ActionMaintaining and Servicing the Appliance Risk of injury or property damage Before servicingMaintenance and Service Tasks Inspect Maintenance TasksAppliance Dimension Diagram Reference MaterialsCARODG42I, CARODG42IL #15 Non Combustible Board Log Set AssemblyService Parts List Part number list on followingStocked At DepotCARODG42I, CARODG42IL #14 Non Combustible BoardTouch up Paint, Fiber Additional service part numbers appear on followingPatch Kit, Fiber Conversion Kit NG#15 Valve Assembly Warranty Outdoor Lifestyles Warranty 2108-975A 10/05/09Limitations of Liability Contact Information