Hearth and Home Technologies CARDOG36IL, CARODG36I, CARDOG42I Install Firescreen, Insert Rod

Page 22

G. Install Firescreen

Firescreen must be installed if not installing optional screen door.

•Remove screen and screen rods from packaging.

•Lay the two sides of screen side by side, rings on top, handles meeting in the middle.

•Insert one screen rod through the rings on top. See Figure 8.11.

•Repeat for other screen.

Insert Rod

Figure 8.11 Insert Rod into Firescreen

•Remove two screws from the ﬁrebox top, set aside.

•Fasten rod with one of the screws removed from the ﬁrebox top, into the hole shown in Figure 8.12.

Figure 8.14 Fasten Screen Rod to Firebox Top

•Repeat with the right screen.

Screw			Screw
for
				for
right screen

			left screen

Figure 8.12 Remove Screws from Firebox Top

•Insert left end of the rod in the left screen (handle is on the right) into the hole in the upper left ﬁrebox side.

Insert Left

Screen Rod

Figure 8.13 Insert Screen Rod

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11

22

Image 22

Contents CARODG36I CARODG36IL CARODG42I CARODG42IL Congratulations Listing Label Information/LocationTable of Contents Listing and Code Approvals Getting Started Design and Installation ConsiderationsIf this ﬁreplace is to be installed within a wall, you must Tools and Supplies NeededFraming and Clearances Stand-Alone InstallationBuilt-in Installation Select Appliance LocationClearances and Framing Dimensions CARODG36I, CARODG36IL 1448 mm MinimumNot be placed between Fireplace opening Ceiling/overhang Fireplace Flashing Appliance PreparationSecuring and Leveling Appliance Position, level, and secure the applianceFuel Conversion Control Box Access PanelGas Information Gas PressureValve Access Connect Incoming Gas Line to Manual Shutoff ValveIntelliFire Plus Pilot Ignition System Wiring Electrical InformationNine Hour Safety Shutdown Feature Control Module OperationInstalling the Optional Electric Kit Match holesWire the GFI receptacle as shown below Assemble the junction boxMantel Projections Facing MaterialPilot Shield Install Lava RockPositioning the Logs Notch against grate CAROLINA-42 Place left center log in the indentations on the front left Place Remaining Lava RockLog and the top left log as shown in Figure Install Firescreen Insert RodYour Fireplace Screens Gas Fireplace SafetyOperating Instructions Before Lighting FireplaceLighting the Appliance Final inspection byInitial Break-in Procedure After the Appliance is LitTroubleshooting IntelliFire Plus Ignition SystemTroubleshooting Symptom Possible Cause Corrective ActionMaintaining and Servicing the Appliance Risk of injury or property damage Before servicingMaintenance and Service Tasks Inspect Maintenance TasksAppliance Dimension Diagram Reference MaterialsCARODG42I, CARODG42IL #15 Non Combustible Board Log Set AssemblyService Parts List Part number list on followingStocked At DepotCARODG42I, CARODG42IL #14 Non Combustible BoardTouch up Paint, Fiber Additional service part numbers appear on followingPatch Kit, Fiber Conversion Kit NG#15 Valve Assembly Warranty Outdoor Lifestyles Warranty 2108-975A 10/05/09Limitations of Liability Contact Information