Hearth and Home Technologies CARDOG42IL, CARODG36I, CARDOG36IL owner manual Notch against grate

Page 19

• Place the left front log on the grate against the front of the

• Place the top left log into the indentations on the rear and

grate. Fit notch in log to grate bar as shown below.

left front logs.

Notch against grate

 

 

Figure 8.8

Place Top Left Log - 36

 

 

 

Figure 8.5 Place Left Front Log - 36

• Place the fork of the center Y log above the middle front

• Place right front log on the grate against the front of the

grate bar and rest its back on the indentation in the middle

grate. Fit notches into the bottom of the log to position it

of the rear log.

as shown in Figure 8.6

 

 

 

 

 

 

 

 

Figure 8.9 Place Center Y Log - 36

Figure 8.6 Place Right Front Log

Place the top center log as shown below.

Place the top right log. There are flat indentations on the rear and right front logs to locate the top right log.

Figure 8.10 Place Top Center Log -36

Figure 8.7 Place Top Right Log - 36

Place the left and right center logs as shown in Figure 8.10

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11

19

Image 19
Contents CARODG36I CARODG36IL CARODG42I CARODG42IL Listing Label Information/Location CongratulationsTable of Contents Listing and Code Approvals Tools and Supplies Needed Design and Installation ConsiderationsIf this fireplace is to be installed within a wall, you must Getting StartedSelect Appliance Location Stand-Alone InstallationBuilt-in Installation Framing and Clearances1448 mm Minimum Clearances and Framing Dimensions CARODG36I, CARODG36ILNot be placed between Fireplace opening Ceiling/overhang Fireplace Position, level, and secure the appliance Appliance PreparationSecuring and Leveling Appliance FlashingGas Pressure Control Box Access PanelGas Information Fuel ConversionConnect Incoming Gas Line to Manual Shutoff Valve Valve AccessElectrical Information IntelliFire Plus Pilot Ignition System WiringControl Module Operation Nine Hour Safety Shutdown FeatureMatch holes Installing the Optional Electric Kit Assemble the junction box Wire the GFI receptacle as shown belowFacing Material Mantel ProjectionsPilot Shield Install Lava RockPositioning the Logs Notch against grate CAROLINA-42 Place left center log in the indentations on the front left Place Remaining Lava RockLog and the top left log as shown in Figure Insert Rod Install FirescreenBefore Lighting Fireplace Gas Fireplace SafetyOperating Instructions Your Fireplace ScreensFinal inspection by Lighting the ApplianceAfter the Appliance is Lit Initial Break-in ProcedureIntelliFire Plus Ignition System TroubleshootingSymptom Possible Cause Corrective Action TroubleshootingRisk of injury or property damage Before servicing Maintaining and Servicing the ApplianceInspect Maintenance Tasks Maintenance and Service TasksReference Materials Appliance Dimension DiagramCARODG42I, CARODG42IL Part number list on following Log Set AssemblyService Parts List #15 Non Combustible BoardAt Depot Stocked#14 Non Combustible Board CARODG42I, CARODG42ILConversion Kit NG Additional service part numbers appear on followingPatch Kit, Fiber Touch up Paint, Fiber#15 Valve Assembly Outdoor Lifestyles Warranty 2108-975A 10/05/09 WarrantyLimitations of Liability Contact Information