Hearth and Home Technologies CARODG36I, CARDOG42I, CARDOG36IL Listing and Code Approvals

Page 4

1 Listing and Code Approvals

A. Appliance Certification

MODELS: CARODG36I, CARODG36IL,

CARODG42I, CARODG42IL

LABORATORY: Underwriters Laboratories, Inc. (UL)

TYPE: Outdoor Open-Flame Decorative Gas Appliances

STANDARD: ANSI Z21.97-2008

This product is listed to ANSI standards for “Outdoor Open- Flame Decorative Gas Appliances” and “Gas Fired Appli- ances for Use at High Altitudes”.

Note: This installation must conform with local codes. In the absence of local codes you must comply with the National Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. and the CAN/CGA B149 Installation Codes in Canada.

D. Noncombustible Materials Specification

Material which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136, Stan- dard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750 ºC and UL763 shall be considered noncombustible materials.

E. Combustible Materials Specification

Materials made of or surfaced with wood, compressed paper, plant fibers, plastics, or other material that can ignite and burn, whether flame proofed or not, or plastered or unplastered shall be considered combustible materials.

Note: This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes with the National Electrical Code, ANSI/ NFPA 70, if applicable.

B. BTU Specifications

 

Min/Max Input

Orifice Size

Models

BTUH

(DMS)

CARODG36I (NG)

36,000/55,000

#27 / .144

 

 

 

CARODG36IL (LP)

29,000/50,000

#46 / .081

 

 

 

CARODG42I

33,000/65,000

#24 / .152

 

 

 

CARODG42IL

37,000/62,000

#43 / .089

 

 

 

F. Electrical Codes

If this appliance will be wired, the following applies:

NOTICE: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70- latest edition or the Canadian Electric Code CSA C22.1.

G. Fuel

This appliance must not be used to burn solid fuel.

Note: See Section 6.A. for flame adjustment.

C. High Altitude Installations

NOTICE: If the heating value of the gas has been reduced, these rules do not apply. Check with your local gas utility or authorities having jurisdiction.

When installing above 2000 feet elevation:

In the USA: Reduce input rate 4% for each 1000 feet above 2000 feet.

In CANADA: Reduce input rate 10% for elevations between 2000 feet and 4500 feet. Above 4500 feet, consult local gas utility.

Check with your local gas utility to determine proper orifice size.

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11

4

Image 4
Contents CARODG36I CARODG36IL CARODG42I CARODG42IL Congratulations Listing Label Information/LocationTable of Contents Listing and Code Approvals Design and Installation Considerations If this fireplace is to be installed within a wall, you mustGetting Started Tools and Supplies NeededStand-Alone Installation Built-in InstallationFraming and Clearances Select Appliance LocationClearances and Framing Dimensions CARODG36I, CARODG36IL 1448 mm MinimumNot be placed between Fireplace opening Ceiling/overhang Fireplace Appliance Preparation Securing and Leveling ApplianceFlashing Position, level, and secure the applianceControl Box Access Panel Gas InformationFuel Conversion Gas PressureValve Access Connect Incoming Gas Line to Manual Shutoff ValveIntelliFire Plus Pilot Ignition System Wiring Electrical InformationNine Hour Safety Shutdown Feature Control Module OperationInstalling the Optional Electric Kit Match holesWire the GFI receptacle as shown below Assemble the junction boxMantel Projections Facing MaterialPilot Shield Install Lava RockPositioning the Logs Notch against grate CAROLINA-42 Place left center log in the indentations on the front left Place Remaining Lava RockLog and the top left log as shown in Figure Install Firescreen Insert RodGas Fireplace Safety Operating InstructionsYour Fireplace Screens Before Lighting FireplaceLighting the Appliance Final inspection byInitial Break-in Procedure After the Appliance is LitTroubleshooting IntelliFire Plus Ignition SystemTroubleshooting Symptom Possible Cause Corrective ActionMaintaining and Servicing the Appliance Risk of injury or property damage Before servicingMaintenance and Service Tasks Inspect Maintenance TasksAppliance Dimension Diagram Reference MaterialsCARODG42I, CARODG42IL Log Set Assembly Service Parts List#15 Non Combustible Board Part number list on followingStocked At DepotCARODG42I, CARODG42IL #14 Non Combustible BoardAdditional service part numbers appear on following Patch Kit, FiberTouch up Paint, Fiber Conversion Kit NG#15 Valve Assembly Warranty Outdoor Lifestyles Warranty 2108-975A 10/05/09Limitations of Liability Contact Information