Kenmore 148.1615421 Natural Gas Connection Preparation, Operating Instructions, To disconnect

Natural Gas Conversion Kit

To purchase a Natural Gas Conversion Kit call Sears at

1-800-4-MY-HOME○R

Natural gas conversion kit Kenmore Model # 10478 (Manufacturer Part No.: 2818-2T-KIT)

Your grill can be converted to natural gas with this conversion kit by a qualified gas technician only. In order to convert this grill the technician will need this conversion kit.

The kit contains orifices for various grill models. Please select the orifices as listed below and discard the rest. Follow the conversion instruction provided with the kit.

Model Main Burner 1.37 mm

148.16154210 4

Natural Gas Connection Preparation:

1.Turn off gas supply, and then remove cap on gas supply side.

2.Recommended: Install a shut-off valve on gas supply side before installing the socket.

3.Socket should be installed by an authorized technician in accordance with the national fuel gas code (NFPA 54/ANSI223.1).

4.Before inserting plug, turn on gas supply and leak test all connections including the stem of the shut-off valve and the opening of the socket. For best results, use an ammonia-free soap & water solution.

Operating Instructions:

1. To connect, push back socket sleeve.

Socket Sleeve Plug

12 ft. extension hose with 3/8 in. ID (inner diameter) If converting the grill to natural gas, the technician in most cases will need this 12 ft. extension hose with 3/8" ID (inner diameter), which is included in the natural gas conversion kit.

2.Insert plug and release sleeve.

3.Push plug until sleeve snaps forward. (Gas will flow automatically. Failure to connect plug properly to socket will inhibit gas flow to the appliance.)

Socket Sleeve

To disconnect

1.Pull Sleeve back. Pull plug out of socket. (Gas is automatically shut off.)

2.Close shut-off valve or turn off gas supply, and replace dust caps on socket and plug.

Gas Requirements

LP Gas

Now that your grill is converted to Natural Gas use, it is set for 7-inch water column (WC) pressure, and cannot be used with Propane Gas. The factory-supplied regulator and hose must be used with a 20-lb. LP gas tank.

11