5.If ignition does not occur in 5 seconds, turn the burner control off, wait 5 minutes for gas to clear away, and repeat the lighting procedure.
6.To light other burners, repeat step 4.
NOTE: If ignitor does not work, follow Match Lighting instructions.
Burner Flame Check
•Remove cooking grates and heat diffusers. Light burners, rotate knobs from HIGH to LOW. You should see a smaller flame in LOW position than seen on HIGH. Perform burner flame check on sideburner, also. Always check flame prior to each use.
Turn controls and gas source or tank OFF when not in use.
If ignition does not occur in 5 seconds, turn the burner control off, wait 5 minutes, and repeat the lighting
procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Do not lean over grill while lighting.
1.Open lid during lighting.
2.Place match into match holder (hanging from side of cart). Light match, place into the firebox.
3.Push in and turn right knob to HIGH position. Be sure burner lights and stays lit.
4.Light other burners by pushing knob in and turning to HI position.
Turning Grill Off
•Turn all knobs to position. Turn LP cylinder off by turning
Ignitor Check
•Turn gas off at LP cylinder. Push the control knob in and turn the knob to the left to “HI” position."Click" should be heard and spark seen each time between collector box or burner and electrode. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP cylinder before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LOW position then turn back to OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only identical replacement part valve/hose/regulator as specified in the Parts List of this Use and Care Guide.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
•Plastic parts: Wash with warm soapy water and wipe dry. Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Porcelain surfaces: Because of
•Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.
8