OPERATING INSTRUCTIONS | 23 |
|
|
MAIN BURNER MANUAL LIGHTING
DANGER
Failure to open the lid while igniting the barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive
1)Open the lid.
2)Make sure all burner control knobs are turned off. (Push each knob in and turn clockwise to ensure they are in the “OFF” position.)
WARNING: The burner control knobs must be in the “OFF” position before turning on the liquid propane cylinder valve. If they are not in the “OFF” position, when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn off the LP tank valve and burner control knobs. Then start over.
DANGER
MAIN BURNER MANUAL LIGHTING
1
2 5
*The grill illustrated may have slight differences than the model purchased.
6
3
When the “excess gas flow control” feature is activated, a small amount of gas is still flowing to the burners. After turning off the cylinder and burner control knobs, wait at least 5 minutes for the gas to clear before attempting to light the barbecue. Failure to do so may result in an explosive
25
3)Turn the cylinder on by turning the cylinder valve counterclockwise.
4)Put match in the match holder and strike match.
WARNING: Do not lean over open barbecue.
5)Insert match holder and lit match down through cooking grates and Flavorizer® bars to ignite the selected burner.
6)Push the control knob in and turn to ”START/HI”.
WARNING: If the burner does not light, turn the burner control knob to “OFF” and wait 5 minutes to let the gas clear before you try again.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to “OFF” position.Turn gas supply off at the source.
LIGHTING THE SIDE BURNER
DANGER
Failure to open the lid while igniting the side burner, or not waiting 5 minutes to allow the gas to clear if the side burner does not light, may result in an explosive
WARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
1)Open the side burner lid.
2)Check that the side burner valve is turned off (Push control knob in and turn clockwise to ensure that it is in the “OFF” position) and all main burner control valves are off (push in and turn clockwise).
3)Turn the gas supply valve on.
4)Push down and turn the side burner control valve to “HI”.
5)Press the igniter button several times so it clicks each time.
CAUTION: Side burner flame may be difficult to see on a bright sunny day.
WARNING: If the side burner does not light:
a)Turn off the side burner control valve, main burners and gas supply at source.
b)Wait 5 minutes to let the gas clear before you try again, or try lighting with a match (see “Manually Lighting the Side Burner”).
SIDE BURNER LIGHTING |
|
|
| 1 |
|
| 5 |
|
| 2 | 4 |
2 | 3 |
|
WWW.WEBER.COM®