Weber Liquid Propane Grill, 55052 0100 manual Assemble wheel frame, Assemble frame

Page 11

Assembly Instructions

Assemble wheel frame

You will need: axle rod, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood. Place one end of the axle rod on the block of wood (or other protected surface). Tap one hubcap onto the end of the axle rod. Slide one wheel onto the axle, WEBER name facing out. Next, slide the other end of the axle rod through the wheel frame. Add the other wheel, WEBER name side facing out. Tap the hubcap onto the axle rod to complete the axle.

EB

R

W

 

W

 

E

 

 

R

B

Assemble frame

You will need: left frame, right frame, two 1/2 inch bolts, two nylon washers and a 7/16 inch or adjustable wrench.

Note - Work on carpeted area (on grass or one of the boxes) to protect the finish during frame assembly. Lay the leg frame pieces as shown so the leg tabs point up.

1)Connect the two frame pieces with the tabs inside of the frame.

2)Slip washers on bolts, then insert bolts as shown and tighten. (If you try to insert a bolt and there is no hole, you have the left frame turned the wrong way. Turn the left frame around.)

(1)

(2)

B068.a

B-1

Image 11
Contents Gas Grill Liquid Propane GAS Units only Palatine, IL Customer Service CenterSouth Hicks Road Contents Operating For Installation in CanadaStorage Genesis Silver-C LP Page Page Page Page Assemble frame Assemble wheel frameAdd front panel Continue frame assemblyComplete frame assembly You will need caster frame and wheel frameInsert casters Add cooking box assemblyAdd fuel gauge Install cylinder panelFrame brace2 You will need burner control knobs Install igniterCheck that all burner valves are off You will need manifold bracket Install manifold bracketInstall the slide out bottom tray You will need lid, two hair pin cotters1 and two hinge pins2 Install LidRight swing-up work surface Install the right end trim piece with tool holdersBoard Do not use the swing-up work surface as a cuttingYou will need side burner Install side burnerWay and do not add bolts yet Install the left end trim piece and swing-up workShown, do not push the trim piece in all Do not use the work surface as a cutting board Install the work surfaceYou will need work surface Closed. Close by turning clockwise Connection. Using a wrench could damageFill liquid propane cylinder Regulator coupling and could cause a gas leakLeaks. Sparks or open flames will result Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Flames in the area while you check forYou will need Bottom shelf Install the thermometerYou will need Thermometer Summary lighting instructions are on the control panel LightingTo Extinguish Manual Lighting Lighting only the side burner Lighting the Side BurnerStorage and/or Nonuse CleaningCooking Important LP Cylinder Information Refilling the Liquid Propane CylinderRemoval of the LP cylinder Liquid Propane Cylinder To Connect the hose to the cylinderLiquid Propane Cylinder requirements Safe handling tips for Liquid Propane Gas CylindersLiquid Propane LP Cylinders Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure Replacing Main Burners Crossover Ignition System Operations Orange flame, in conjunction with Barbecue temperature onlyFlame is low when burner is on Burners burn with a yellow orConjunction with the smell of gas Side Burner does not lightFlame is low in High position Flame is very yellow