Weber 55052 0100 Do not use an open flame to check for gas, Fire or explosion, which can cause

Check for gas leaks	m WARNING: Do not ignite burners when leak
m DANGER	checking.
	Check for leaks by wetting the connections with the
Do not use an open flame to check for gas	soap and water solution and watching for bubbles. If
leaks. Be sure there are no sparks or open	bubbles form or if a bubble grows, there is a leak.
flames in the area while you check for	Check:
leaks. Sparks or open flames will result in	1) Hose to manifold connection.
	m WARNING: If there is a leak at connection (1),
a fire or explosion, which can cause
	retighten the fitting with a wrench and recheck for
serious bodily injury or death and damage	leaks with soap and water solution.
to property.	If a leak persists after re-tightening the fitting, turn
	OFF the gas. DO NOT OPERATE THE BARBECUE.
m WARNING: You should check for gas leaks every	Contact the Customer Service Representative in
time you disconnect and reconnect a gas fitting.	your region using the contact information sheet
Note - All factory-made connections have been	provided with your manual.
thoroughly checked for gas leaks. The burners have	2) Regulator to cylinder connection.
been flame-tested. As a safety precaution however,	3) Manifold to side burner hose connection.
you should recheck all fittings for leaks before using	4) Side burner hose to side burner connection.
your Weber Gas Barbecue. Shipping and handling may	5) Valves to manifold connections.
loosen or damage a gas fitting.	6) Hose to regulator connection.
m WARNING: Perform these leak checks even if	m WARNING: If there is a leak at connections
your barbecue was dealer or store assembled.	(2,3,4,5 or 6), turn OFF the gas. DO NOT OPERATE
You will need: a soap and water solution, and a rag or	THE BARBECUE. Contact the Customer Service
brush to apply it.	Representative in your region using the contact
Note - Since some leak test solutions, including soap	information sheet provided with your manual.
and water, may be slightly corrosive, all connections	When leak checks are complete, turn gas supply OFF
should be rinsed with water after checking for leaks.	at the source and rinse connections with water.
Make sure side burner is OFF.
	(1)
	(2)

To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise.

(3)

(4)

(6) (5)

C-7