Insert casters
You will need: frame assembly and two casters. Push the casters firmly into the inserts in the ends of the caster frame.
Add cooking box (assembly)
You will need: frame assembly, cooking box (assem- bly), 2 inch bolt, nylon washer, keps nut, pliers and a 7/ 16 inch or adjustable wrench.
Uncoil the hose.
Place the cooking box (assembly) in the frame assem- bly so the burner tubes(1) are under the frame brace(2).
(1)
(2)
Slide the cooking box (assembly) to the left within the frame assembly. Add the nylon washer to the bolt. Insert the bolt through the frame and cooking box with the head of the bolt outside the box. Add the keps nut. Tighten by holding the bolt with pliers while you tighten the nut with a wrench.
Your Weber Gas Grill manifold assembly, consisting of gas manifold, valves, hose, regulator and gas burners has been factory assembled, pressure and flame tested. As a safety precaution, we recommend you check the burner alignment:
1)Are the ends of the burners under the washers at the left rear and left front of the cooking box? The screws are only guides. Do not tighten.
2)Do the valves fit into the ends of the burners?
3)Are the wing nuts under the burner assembly tight?
If you answered YES to 1, 2 and 3, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact the Customer Service Represen- tative in your region using the contact information sheet provided with your manual. Do not use grill.
(2)
(1)
(3)