Weber Liquid Propane Grill, 55052 0100 manual Install the left end trim piece and swing-up work

Connect the side burner hose as follows:		Install the left end trim piece and swing-up work
1)	Slide back the collar of the quick disconnect	surface
	on the manifold.	You will need: End trim piece, swing-up work surface,
2)	Push the male fitting of the side burner hose	swing-up work surface rod, two 1/2 inch bolts, two
	into the quick disconnect, and maintain	nylon washers and a wrench
	pressure. Slide the collar closed.	1.) Start the left end trim piece into the frame as
		shown, do not push the trim piece in all of the
		way and do not add bolts yet.

(1)

(2)

2.) Slide the swing-up work surface rod through the holes at the top of the swing-up work surface.

Quick disconnect will be engaged.
Check to be sure that the side burner valve is OFF.
Push the side burner control knob down and turn it
clockwise. If it doesn’t turn, the valve is OFF. If it does	3.) Insert one end of the swing-up work surface rod
turn, continue turning it clockwise until it stops, then
	into the hole in the frame.
the burner is OFF.

C-4