Weber Liquid Propane Grill, 55052 0100 Do not use the swing-up work surface as a cutting, Board

4.) While holding swing-up work surface in position,	To raise swing-up work surface: Lift table all the way up
insert the other end of the swing-up work surface	and slide it to the left, then lower table until you feel it
rod into the right end trim piece (1). Push the trim	lock in the up position.
piece into the frame as shown, making sure that
the tab on the back underside piece of the trim	To lower swing-up work surface: Lift table up until it
piece is snapped into the slot in the rear frame (2).	disengages and slide it to the right. Then lower it all the
View from underneath	way down so that the locking pin on the right side of
(2)	the table fits into the locking bracket on the leg, which
	will secure the table in the down position.
	Do not use the swing-up work surface as a cutting
	board.

(1)

5.) Add a washer to the bolt and insert it through the front hole in the frame and the hole in the trim piece. Tighten with a wrench.

View inside of control panel

C-2