Weber Liquid Propane Grill, 55052 0100 manual Install igniter, Check that all burner valves are off

Page 15

Install igniter

Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.

The igniter lock nut is on the igniter.

1)Loosen the igniter lock nut.

2)Insert the top of the igniter up through the large part of the keyhole in the frame brace. Slide the igniter into the small part of the keyhole.

3)Tighten the igniter lock nut back onto the igniter. Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

(1)

(2)

(3)

Check that all burner valves are off

You will need: burner control knobs.

Valves are shipped in the OFF position, but you should check to be sure that they are turned OFF. Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off. Proceed to the next step. If they do turn continue turning them clockwise until they stop, then they are off. Proceed to the next step.

B-5

Image 15
Contents Gas Grill Liquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents For Installation in Canada StorageOperating Genesis Silver-C LP Page Page Page Page Assemble frame Assemble wheel frameAdd front panel Continue frame assemblyComplete frame assembly You will need caster frame and wheel frameInsert casters Add cooking box assemblyInstall cylinder panel Frame brace2Add fuel gauge Install igniter Check that all burner valves are offYou will need burner control knobs Install manifold bracket Install the slide out bottom trayYou will need manifold bracket You will need lid, two hair pin cotters1 and two hinge pins2 Install LidRight swing-up work surface Install the right end trim piece with tool holdersBoard Do not use the swing-up work surface as a cuttingYou will need side burner Install side burnerInstall the left end trim piece and swing-up work Shown, do not push the trim piece in allWay and do not add bolts yet Install the work surface You will need work surfaceDo not use the work surface as a cutting board Closed. Close by turning clockwise Connection. Using a wrench could damageFill liquid propane cylinder Regulator coupling and could cause a gas leakLeaks. Sparks or open flames will result Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open Flames in the area while you check forInstall the thermometer You will need ThermometerYou will need Bottom shelf Lighting To ExtinguishSummary lighting instructions are on the control panel Manual Lighting Lighting only the side burner Lighting the Side BurnerCleaning CookingStorage and/or Nonuse Refilling the Liquid Propane Cylinder Removal of the LP cylinderImportant LP Cylinder Information Liquid Propane Cylinder To Connect the hose to the cylinderSafe handling tips for Liquid Propane Gas Cylinders Liquid Propane LP CylindersLiquid Propane Cylinder requirements Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Orange flame, in conjunction with Barbecue temperature onlyFlame is low when burner is on Burners burn with a yellow orConjunction with the smell of gas Side Burner does not lightFlame is low in High position Flame is very yellow