Weber 55052 0100, Liquid Propane Grill Lighting the Side Burner, Lighting only the side burner

Page 28

Lighting the Side Burner

The side burner has a separate ignition system from the main cooking box.

DANGER

Failure to open the lid while igniting the side burner, or not waiting 5 minutes to allow the gas to clear if the side burner does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

Lighting only the side burner.

1)Open the side burner lid.

2)Check that the fuel gauge reads more than “E”.

3)Check that the side burner valve is turned OFF. (Push each knob down and turn clockwise to ensure they are in the off position.), and all main burner control valves are OFF (push down and turn clockwise).

4)Turn the LP tank valve on (turn clockwise).

5)Push down and turn the side burner control valve to HI.

6)Push the side burner igniter button several times so it clicks each time.

1

5

3

6

CAUTION: Side burner flame may be difficult to see on a bright sunny day.

WARNING: If the side burner does not light:

1)Turn OFF the side burner control valve.

2)Wait 5 minutes to let the gas clear before you try again or try to light with a match.

Lighting the side burner if the main burners are lit.

1)Open the side burner lid.

2)Push down and turn the side burner control to HI.

3)Press the side burner igniter button several times so it clicks each time.

1

2

3

CAUTION: Side burner flame may be difficult to see on a bright sunny day.

WARNING: If the side burner does not light:

1)Turn OFF the side burner control valve.

2)Wait 5 minutes to let the gas clear before you try again or try to light with a match.

D-3

Image 28
Contents Gas Grill Liquid Propane GAS Units only South Hicks Road Customer Service CenterPalatine, IL Contents Storage For Installation in CanadaOperating Genesis Silver-C LP Page Page Page Page Assemble wheel frame Assemble frameContinue frame assembly Complete frame assemblyYou will need caster frame and wheel frame Add front panelAdd cooking box assembly Insert castersFrame brace2 Install cylinder panelAdd fuel gauge Check that all burner valves are off Install igniterYou will need burner control knobs Install the slide out bottom tray Install manifold bracketYou will need manifold bracket Install Lid You will need lid, two hair pin cotters1 and two hinge pins2Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerShown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet You will need work surface Install the work surfaceDo not use the work surface as a cutting board Connection. Using a wrench could damage Fill liquid propane cylinderRegulator coupling and could cause a gas leak Closed. Close by turning clockwiseDo not use an open flame to check for gas Leaks. Be sure there are no sparks or openFlames in the area while you check for Leaks. Sparks or open flames will resultYou will need Thermometer Install the thermometerYou will need Bottom shelf To Extinguish LightingSummary lighting instructions are on the control panel Manual Lighting Lighting the Side Burner Lighting only the side burnerCooking CleaningStorage and/or Nonuse Removal of the LP cylinder Refilling the Liquid Propane CylinderImportant LP Cylinder Information To Connect the hose to the cylinder Liquid Propane CylinderLiquid Propane LP Cylinders Safe handling tips for Liquid Propane Gas CylindersLiquid Propane Cylinder requirements Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Replacing Main Burners Crossover Ignition System Operations Barbecue temperature only Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction withSide Burner does not light Flame is low in High positionFlame is very yellow Conjunction with the smell of gas